Harman-Kardon DPR 1001 Front Panel Controls, Power Indicator will turn green when the unit is on

FRONT PANEL CONTROLS

* & ^ % $

1

				7
1		3	5
					(	Ó !Ô			Ò@		#
		4	6	8	9	)
2										Ú
	Power Indicator			9 ¤ Button			I Main Power Switch
1 Standby/On Button				! Set Button			J Headphone Jack
	Surround Mode Selector			B ⁄ Button			K Digital Optical 3 Input
3 Surround Select Button				C Door			L Input/Output Status Indicators
4 AM/FM Selector				D Volume Control			M Digital Coax 3 Jack
5 Input Source Selector				E System Configuration Indicators			N Video 4 Input/Output Jacks
6 Tuning Mode Selector				F Main Information Display
7 Tuning Selector				G Input Indicators
8 Preset Station Selector				H Surround Mode Indicators

NOTE: To make it easier to follow the installation instructions that refer to this illustration, a larger copy may be downloaded from the Product Support section at www.harmankardon.com.

Power Indicator: This LED turns red when the unit is in the Standby mode to signal that the unit is ready to be turned on. When the unit is in operation, the indicator will turn green.

2Standby/On Button: When the Main Power Switch I is “ON,” press this button to turn on the DPR 1001; press it again to turn the unit off. The

Power Indicator will turn green when the unit is on.

NOTE: The Main Power Switch ( must be turned on before this button will operate.

Surround Mode Selector: Press this button to choose a surround processing format category by scrolling through the list of available formats as indicated in the Surround Mode Indicators H.

These format categories are: Dolby surround modes, DTS Digital modes, DTS Neo:6 modes, Logic 7 modes, DSP modes and Stereo modes. Once you have selected a format category, use the Surround Select Button 3 to choose a specific mode within the overall category.

3Surround Select Button: After choosing a surround processing format category by using the Surround Mode Selector , press this button to scroll through the list of available modes for that for- mat category. For example, to select the 7.1 Logic 7 Cinema mode, press the Surround Mode Selector

until the indicator next to Logic 7 H is lit. Then press the Surround Select Button 3 to scroll through the available choices until the desired mode appears in the Main Information Display F. (For more information see page 26.)

4AM/FM Selector: Pressing this button will auto- matically switch the DPR 1001 to the Tuner mode. Pressing it again will switch between the AM and FM frequency bands. (See page 28 for more information on the tuner.)

5Input Source Selector: Press this button to change the input by scrolling up or down through the list of input sources.

6Tuning Mode Selector: This button is used to switch back and forth between the Auto and Manual tuning modes. In Auto mode, you may use the Tuning Selector 7 to scan through stations with an accept- able signal. In Manual mode, you may use the Tuning Selector 7 to step through one frequency increment at a time.

FRONT PANEL CONTROLS 5