Furuno GP-1850F manual 11.3 GPS/DGPS/TD Options menu, 11-5, GPS Setup Options menu description

Page 73

11.3GPS/DGPS/TD OPTIONS menu

This menu sets up GPS and DPGS receiv- ers and enables display of position in Loran C or Decca TDs.

1.Press the [MENU] key.

2.Press the soft key GPS/DGPS/TD OP- TIONS to display the GPS/DGPS/TD op- tions menu.

GPS/DGP

OPTION

GPS SETUP OPTIONS

DGPS SETUP OPTIONS

TD SETUP

DGPS 3D

 

 

 

RETURN

 

 

 

Figure 11-7 GPS/DGPS/TD options menu

GPS SETUP OPTIONS menu description

This menu provides items for setting up the GPS receiver. To display it, show the menu shown in Figure 11-7, and then press the soft key GPS SETUP OPTIONS.

 

 

 

 

 

 

 

GPS

 

 

sLOCAL TIME OFFSET

+00:00

 

 

OPTION

 

 

 

 

 

 

 

 

GEODETIC DATUMS

WGS-84

 

 

 

 

 

 

 

 

EDIT

 

 

 

POS SMOOTHING

000 sec

 

 

 

 

 

SPD/CSE SMOOTHING

005 sec

 

 

 

 

 

 

GPS SPEED AVE

060 sec

 

 

 

 

 

 

LAT OFFSET

0.000’N

 

 

 

 

 

 

LON OFFSET

0.000’E

 

 

 

 

 

 

DISABLE SATELLITE

_ _ _ _ _ _

 

 

 

 

 

 

LATITUDE

38° 00.000’N

 

 

 

 

 

 

LONGITUDE

123° 00.000’W

 

 

 

 

 

 

ANT. HEIGHT

005 m

 

 

 

 

 

 

FIX MODE

2D/3D

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

DGPS 3D

 

 

RETURN

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Figure 11-8 GPS SETUP options menu

LOCAL TIME OFFSET

GPS uses UTC time. If you would rather use local time, enter the time difference between local time and UTC time. Use the soft key +<-->- to switch from plus to minus and vice versa.

GEODETIC DATUM

Your equipment is preprogrammed with most of the major chart systems of the world. Al- though the WGS-84 system, the GPS stan- dard, is now widely used other categories of charts still exist. Select the chart system used, not the area where your boat is sailing. The default chart system is WGS-84.

1.Select GEODETIC DATUMS.

2.Press the soft key EDIT to show the geo- detic datum window.

GEODETIC DATUMS

AUSTRALIA

CHART DATUM

WGS-84

Figure 11-9 Geodetic datum window

3.Press or to select the chart system you are using. If no chart datum exists for geodetic datum selected UNKNOWN ap- pears in the CHART DATUM window. In this case select a different chart system.

4.Press the soft key ENTER or the [ENTER] key to register your selection.

POS SMOOTHING

When the DOP or receiving condition is un- favorable, the GPS fix may change greatly, even if the vessel is dead in water. This change can be reduced by smoothing the raw GPS fixes. A setting between 000 to 999 is available. The higher setting the more smoothed the raw data, however too high a setting shows response time to change in latitude and longitude. This is especially no- ticeable at high ship’s speeds. 000 is the normal setting; increase the setting if the GPS fix changes greatly.

11-5

Image 73
Contents Color DGPS/PLOTTER/SOUNDER Color GPS/PLOTTER/SOUNDER First E D I T I O N FEB OCT Do not open the equipment About the TFT LCDDo not disassemble or modify the equipment Do not operate the equipment with wet handsTable of Contents Iii Declaration of ConformityForeword FeaturesWord to GP-1850DF/1850F Owners Display Unit System ConfigurationThis page is intentionally left blank Display Unit Controls Operational OverviewRemote controller Remote ControllerTurning the Power On/Off Inserting Mini Chart CardTurning the power off Display abbreviationsPlotter Displays Adjusting Tone and BrillianceSelecting a display Menu Operation, Soft Keys Sounder DisplaysPlotter/Sounder Display Normal Sounder DisplayDemonstration Display 11 Demo setting screenPrinciple of Operation Video Sounder OperationNormal sounder display indications, markers Sounder Display DescriptionKHz picture Bottom-zoom display Selecting sounder display modeMarker zoom display Bottom-lock displayDual-frequency Display Plotter/Sounder DisplayScope display EnterManual Sounder Operation Automatic Sounder OperationMeasuring Depth Adjusting the gainSelecting display range Range shiftingSuppressing Interference Sounder Setup OptionsSuppressing Low Level Noise White Marker Erasing Weak EchoesSelecting Background and Echo Colors Selecting Picture Advance SpeedBackground and echo colors Alarms Zero line Interpreting the DisplayFish school echoes Bottom echo34 Surface noise/aeration Surface noise/AerationPresentation Modes Plotter DisplaysNorth-up Course-upMini Chart Cards Selecting Chart Scale/RangeCursor Shifting the DisplayRemarks on chart display Indices and chart enlargementChart symbols Furuno mini chart cardComparison of Furuno and Nav-Charts chart cards Port service icons Nav-Charts cardsAid to navigation data Enlarging an indication Navigation Data DisplayGPS satellite monitor display Steering Display How to read the compass displayBeacon information display Setting the range of the XTE scale How to read the XTE scaleHighway Display Fifure 3-16 Display setup1 menu Changing Operation ModeNavigation Trip Distance FishingDisplaying Track TrackTracking Changing Track Color Stopping/Restarting Plotting of TrackTrack Plotting Method, Interval Track plotting methodTrack plotting interval Changing Track Memory CapacityTrack Memory Erasing All Track Entering Marks MarkPlotter display Video sounder display Changing Mark AttributesTions Changing Mark SizeSmall Displaying Track and Mark Points Erasing MarksErasing individual marks/lines Erasing whole marks/linesEntering Waypoints WaypointsEntering waypoints at own ship’s position Entering waypoints at MOB positionChanging the shape and color of waypoint mark Waypoint menuEntering waypoints by range and bearing Changing waypoint name, comment, proximity alarm radiusEntering waypoints by latitude and longitude position Changing waypoint positionChanging Waypoint Data Erasing Individual WaypointsErasing waypoints through the waypoint list Erasing waypoints by the cursorChanging Waypoint Position on the Plotter Display Waypoint Mark SizeSearching Waypoints This page is intentionally left blank Entering Routes RoutesEntering routes through the route list AbcdefInserting, Removing Waypoints Connecting RoutesEntering routes by the cursor Inserting waypoints through the route listRemoving waypoints from routes Inserting waypoints on the plotter displayAlph List WPTRemoving route waypoints from the plotter display Creating Track-based RoutesSave icon appearance On the plotter display Erasing RoutesThis page is intentionally left blank Navigating to Quick Points NavigationSelecting quick point entry method Navigating to a single quick pointNavigating to Waypoints waypoint list Navigating to Ports, Port ServicesNavigate route waypoints in reverse order Following a RouteNavigate directly to a route waypoint Navigate along specific leg of routeSwitching waypoints Setting speed for ETA calculationRestarting navigation Cancelling Navigation This page is intentionally left blank Audio Alarm On/Off Plotter AlarmsArrival Alarm IntroductionXTE Cross Track Error Alarm Anchor Watch AlarmProximity Alarm Speed AlarmAlarm messages Alarm InformationAlarm messages and their meanings Formatting Memory Cards Saving Data to Memory Card10-1 Saving dataLoading Data from Memory Card Error message10-2 Data overwrite10-3 ConfigurationTrack Waypoint/routeThis page is intentionally left blank Chart Offset menu Chart Setup Options menuCustomizing Your Unit 11-1Chart details menu description Chart Details menuDisplay Options menu 11-211-3 Display setup1 menu description11-4 Display SETUP2 menu description11.3 GPS/DGPS/TD Options menu GPS Setup Options menu description11-5 Dgps Setup Options Dgps Setup Options menu11-6 TD Setup TD Setup menu11-7 Displaying Loran C TDsRange Setup soft key Sounder Setup Options menuSounder Setup Options menu description 11-8System Setup menu description System Setup soft key11-9 Echo Offset 200kHz, Echo Offset 50kHzSetup Nmea Port 1 menu description Configuration menuSetup NMEA/DGPS Port 2 menu description 11-10UPLOAD/DOWNLOAD Data menu 11-11XON/XOFF Download waypoint/route to PC22 Connection of GP-1850DF GP-1850F to PC 11-12System menu 11-13System Menu description This page is intentionally left blank Using C-MAP NT Model Tidal Information Navigating to Ports, Port Services 12-4 Setting Chart Setup Options 20 Depth Info display 12-6Displaying Program Number This page is intentionally left blank Maintenance Maintenance & TroubleshootingRecommended maintenance program 13-1Simple Troubleshooting Replacement of Fuse, BatterySimple troubleshooting plotter 13-2Simple troubleshooting sounder Error MessagesError messages 13-313-4 Diagnostic TestsMemory, I/O port test TestKeyboard test 13-5Display test Clearing Memories Remote controller test13-6 Menu Tree Sounder Setup Options Audio Alarm ON, OFF Loran C Chains Decca Chains World Time Geodetic Chart List GPS Receiver GeneralDisplay Section PlotterSounder Coating Color Index-1 IndexIndex-2 Index-3
Related manuals
Manual 63 pages 6.35 Kb

GP-1850F, GP-1850DF specifications

Furuno is renowned for its high-quality marine electronics, and the GP-1850DF and GP-1850F are no exceptions. These advanced GPS chart plotters are designed to meet the needs of both professional mariners and recreational boaters alike.

The GP-1850DF is equipped with a powerful 12-channel GPS that provides fast and accurate positioning information, while the GP-1850F features a sturdy built-in fish finder, making it ideal for anglers. Both units boast a brilliant color display that enhances visibility in various lighting conditions, ensuring that users can easily read information on the screen, even in direct sunlight.

One of the standout features of these models is their compatibility with a variety of chart formats, including C-MAP, and Furuno’s proprietary raster charts. This flexibility allows users to choose from a broad range of navigational charts, catering to specific regional needs and preferences. The intuitive interface of the GP-1850 series simplifies navigation, offering menu-driven commands and support for multiple languages.

Furuno has integrated advanced sonar technology in the GP-1850F model, including a high-resolution fish finder capable of detecting fish signatures with remarkable precision. The dual-frequency capabilities enable users to switch between higher frequencies for shallow water fishing and lower frequencies for deeper waters. This enriches the fishing experience while improving catch rates.

Moreover, both devices feature a built-in waypoint register, allowing users to store up to 1,000 waypoints, which can be essential for returning to promising fishing spots or navigating back to port. The navigation functions also include routes and track recording, empowering boaters to create custom paths and review their previous journeys.

The GP-1850 series also places a high emphasis on safety, incorporating features like man overboard (MOB) alarms and route alarms to enhance on-water safety. Additionally, they are designed to withstand the harsh marine environment, with waterproof housings that ensure durability during adverse weather conditions.

In conclusion, the Furuno GP-1850DF and GP-1850F models provide an exceptional combination of performance, reliability, and user-friendly features, making them a preferred choice for both fishermen and navigators. Their adaptability in various maritime situations, alongside advanced technologies, cements their reputation as essential tools for successful and safe voyages on the water.