Hans Grohe 28110XX1 Corner Mount Kit, Seal the wall around the anchors with waterproof sealant

Page 8

Corner Mount Kit 28105XX0

Note: The corner mount kit is not for use with the 28108XX1 wall outlet adapter.

Position the corner mount against the wall at the desired location.

Mark the positions of the screw holes. Put the mount aside.

Drill the holes using a 6 mm bit.

Seal the wall around the anchors with waterproof sealant.

Failure to seal the wall can lead to possible water damage.

Install the corner mount with the screws and offset bushings.

Install the Allrounder (see page 10). Tighten the set screw.

Image 8

Contents Installation Instructions / Warranty Raindance AllrounderWall Outlet Adapter with Hose Connection Technical Data Raindance Allrounder28110XX1 Determining the mounting heightRoughing in If you are not using the 28108XX1 wall outlet adapter, go to pageInstallation Do not overtighten, or damage will resultSeal the wall around the anchors with waterproof sealant Failure to seal the wall can lead to possible water damageInstall the handshower Replacement Parts Check Valve Maintenance Backflow prevenCorner Mount Kit Install the 28110XX1 Allrounder Do not drill through the mounting plateFailure to seal the wall can lead to possible water damage Using the Allrounder To adjust the handshower heightGuide the hose over the hose hook Pull or push the Allrounder to the desired positionChange the spray modes Raindance E 150 Air 3-Jet HandshowerLimescale Removal Replacement parts Cleaning Recommendation for Hansgrohe Products Limited Lifetime Consumer WarrantyCleaning Materials for Faucets and Showers Cleaning Instructions for Faucets and ShowersTHIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR Tel. 770-360-9880 Fax US - Installation Instructions Part No. 90661501 Revised 01/2008Hansgrohe, Inc. 1490 Bluegrass Lakes Parkway Alpharetta, GA