Hans Grohe 28110XX1, 2810BXX1 installation instructions Install the handshower

Page 10

Install the anchors.

Seal the wall around the anchors with waterproof sealant.

Failure to seal the wall can lead to possible water damage.

Secure the mounting plate to the wall with the screws and the offset bushings. The set screw should be on top.

Place the Allrounder over the mounting bracket (1). Tighten the set screw (2).

Install the handshower:

Place a black rubber washer in one end of the hose. Connect this end of the hose to the wall outlet (not included).

Place the screen washer in the other end of the hose. Screw it to the handshower.

Image 10

Contents Wall Outlet Adapter with Hose Connection Raindance AllrounderInstallation Instructions / Warranty 28110XX1 Technical DataRaindance Allrounder Determining the mounting heightRoughing in If you are not using the 28108XX1 wall outlet adapter, go to pageInstallation Do not overtighten, or damage will resultSeal the wall around the anchors with waterproof sealant Failure to seal the wall can lead to possible water damageInstall the handshower Replacement Parts Check Valve Maintenance Backflow prevenCorner Mount Kit Install the 28110XX1 Allrounder Do not drill through the mounting plateSeal the wall around the anchors with waterproof sealant Guide the hose over the hose hook Using the AllrounderTo adjust the handshower height Pull or push the Allrounder to the desired positionLimescale Removal Raindance E 150 Air 3-Jet HandshowerChange the spray modes Replacement parts Cleaning Materials for Faucets and Showers Cleaning Recommendation for Hansgrohe ProductsLimited Lifetime Consumer Warranty Cleaning Instructions for Faucets and ShowersTHIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR Hansgrohe, Inc. 1490 Bluegrass Lakes Parkway Alpharetta, GA US - Installation Instructions Part No. 90661501 Revised 01/2008Tel. 770-360-9880 Fax