Bradley Smoker WF3204, TDB3104 installation instructions Module Cover Assembly

Installation Instructions continued . . .

4.Place the actuator module assembly on top of the sprayhead. Drop 1/8" diameter tube down to the valve assembly and connect to the air valve. Make sure the spray holes point away from the wall.

NOTE: Skip to number 5 for units without soap.

•For units with soap option, slide the spacer and soap dispenser over the 1-1/2" pipe.

5.Position the upper tie bar slightly below the module (see Figure 9 inset on previous page) or soap dispenser (see Figure 12) and fasten securely to vent pipe with set screws provided. Secure top cover to tie bar with two cap screws provided.

6.FOR B UNIT: Install 1/2" nominal copper supply lines (pass through holes in cover and through support column) and connect supply lines to stops using suitable fittings.

FOR H UNIT ONLY: Connect supply lines to stops using suitable fittings.

UNIT WITH “H” DRAIN AND ACTUATOR MODULE

SHOWN, ALSO AVAILABLE WITH “B” DRAIN

Figure 10