Craftsman 139.53661SRT1 Care of Your Opener, To reduce the risk of severe, Maintenance Schedule

Page 31

IMPORTANT SAFETY INSTRUCTIONS

'

':-,

;,.i

To reduce the risk of severe

1.READ AND FOLLOW ALL INSTRUCTIONS.

2.Do not permit children either to operate or to play with the opener. Keep remote control In a location inaccessible to children.

3.Operate opener only when the door is in full view and free from any obstruction. Keep the door in sight until it is completely closed. NO ONE SHOULD CROSS THE PATH OF THE MOVING DOOR.

4.Check safety reversal system monthly. See page 30. The garage door MUST reverse on contact with a one-inch (or a 2x4 board I.ald flat) object placed on the floor. If an adjustment is made to either the force or the limit of travel, both adjustments may be needed and the safety reversal system must be checked. Failure to properly adjust the opener may result in severe injury or death.

!WARNING

f..

,

,

,

,

,

i

i

injury or death to persons:

5.If possible, use the emergency release only when the deer is in a closed position. Caution should be taken whenever the disconnect cord

is actuated with the door open. Weak or broken springs may cause the door to fall rapidly, causing injury or death to persons.

6.KEEP GARAGE DOORS PROPERLY BALANCED. See page 3. An improperly balanced door may not reverse when required and could result in severe injury or death. Repairs to cables, spring assemblies and other hardware must be made by a professional garage door person.

7.Disconnect the electric power to the garage door opener before making any repairs or removing the covers.

s.SAVE THESE INSTRUCTIONS.

Care of Your Opener

Limit and force adjustment controls

Limit Controls

Force Controls

AdjustmentLabel

AdJu_at_mtLabe/

(Located on the le/t side panel]

(Locatedon the rightside panel)

Weather conditions may cause some minor changes In door operation requiring some re- adjustments, particularly during the first year of operation.

Pages 28 and 29 refer to the limit and force adjustments. Only a screwdriver is required. Follow the instructions carefully.

Repeat the safety reverse test (page 30) after any adjustment of limits or force.

The remote control

3-FUNCTION

The lithium batteries should

Open thls end

 

produce power for up to

 

5 years. To replace batteries,

 

use the visor clip or screwdriver

 

blade to pry open the case, as

 

shown. (UOpen"location is

COMPAC

 

Twist hem

stamped on back of remote

to oden

 

control case.) Insert batteries positive side down.

Replace cover as follows. 3-Function remote: insert the 3 tabs at the opposite end and snap shut. Compact 3-Functionremote: Snap shut along both sides.

Dispose of old batteries properly.

Maintenance Schedule

Once a Month

Manually operate door. if it is unbalanced or binding, call for professional garage door service.

Check to be sure door opens & closes fully. Adjust limits and/or force it necessary.

(See pages 28 and 29.)

Repeat the safety reverse test. Make any necessary adjustments (See page 30).

Twice a Year

Check chain tension. Disconnect trolley first. Adjust if necessary (See page 11).

Once a Year

Oil door rollers, bearings and hinges. The opener does not require additional lubrication. Do not grease the door tracks.

31

Image 31
Contents Craftsmrn Operation safety Instructions ContentsAdjustment section pages Test the safetyYoull Need Tools Finished Ceiling Center of the door. See pages 12Isaor sigt P,ele=se Garage One-Piece Door Without TrackOne-Piece Door With Track Closed PositionSk2 Carton InventorySecurity+ SquaHo t2Safety Reversing Sensor Installation Hardware Installation HardwareAssemble the T.rail & Attach Cable Pulley Bracket Assembly Section Pages 8Assembly Step Omenlo SasFasten the T-rail to the Opener Assembly StepCover \ Check to make sure the chain Is Install Chain/Cable Attach Sprocket CoverUse the second master link to connect Chain to the flat end of the shaftTighten the Chain & Cable Assembly StepDetermine Header Bracket Location Installation Section Pages 12 Installation StepProceed to , Example Fasten the Header Bracket to the Ceiling Install the Header BracketFasten Header Bracket to the WallAttach the T-rail to the Header Bracket Installation StepPosition the Opener 0SH=OCSlU,G Hang the OpenerBackview Install the Door ControlHardware Shown DryWaAnchomInstall the Light and the Lens Install the lensAttach Emergency Release Rope Handle Electrical Requirements Permanent Wiring ConnectionsFacing the door from inside the garage Safety Reversing SystemAlternate Floor Mount Install the Safety Reversing SensorLag St=paB Alternate Wall Mount WithSlotHI,II,l,l,IliiI,%I,I,I,I,D Fasten Door Bracket TTIJ.etc-,Pr Igure=deEd Figure LockWashe 5/6 Ooor Same way, using the 5/16 x I 1/4 clevis pinHole Alignment Connect Door Arm to TrolleyAssembletheDoorArm Adjustment Procedures for One-Piece DoorsPages 28 Adjustment Section Adjustment StepHow and When to Adjust the Limits Adjust the UP and Down LimitsAdjust the Force How and When to Adjust the ForcesTest The Safety Reversing Sensor Important safety checkTest the Safety Reverse System Care of Your Opener Maintenance ScheduleTo reduce the risk of severe Lock feature is designed to Lock featureOperation of Your Opener Securityi SECURITY,I Receiver and RemoteControl Programming RgureReview the travel limits adjustment procedures on Having a Problem?Probable Cause and Solution Remote control has short rangeDoor opens but wont close Having a Problem?Probable Cause & Solution SituationInstallation Parts Repair PartsRail Assembly Parts 116 Repair PartsOpener Assembly Parts 18173If you have a Premium Control Console AccessoriesFor Sectional Doors Only If you do not have a Premium Control ConsoleSafety wamings 11, 19 Opener Termlnals Access Door/Outside Key Release AccessoryProblems that might require force adjustments Manual Emergency Release Rope & Handle Lockout featureSpanish Please ask For in-home major brand repair service800473-7247 Pare obtener este Manual del