Receiver and Remote, Control Programming

Receiver and Remote

SECURITY

Your garage door opener receiver and remote control have been pre-set at the factory. The door will open

when you press the LARGE remote control push button. The code between the remote control and the

receiver changes with each use, randomly accessing over 100 billion new codes.

The 3-function remote control can also activate additional SECURITY+ garage door openers and/or light controls.

Your SECURITY+ opener will operate with:

•several SECURITY+ remote controls (with blue push buttons) utilizing up to 8 functions.

•one SECURITY+ Keyless Entry System (Model 139.53684).

Follow the instmctionsbelow to program your opener to match any additional remotes you may purchase.

See Accessories on page 38.

Control Programming

To comply with FCO roles, adjustment or modifications of _s receiver and/or

I_ilter are ptohlbited, except for changing the code setling or ,_placing Ihe battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.

Children operating or playing with a garage door opener can injure themselves or others. The garage door could close and cause serious

injury or death. Do not allow children to operate the door push button(s) or remote control(s).

A moving garage door could injure or kill someone under it. Activate the opener only when you can sea the door clearly, it is free of obstructions, and is properly adjusted.

Rgure I

Select = remotecontrolpush buttonto o_emlo opener

To Add A Remote Control If you have a Premium Control Console:

1.	With the door closed, press and hold a remote
	control push button. See Figure 1.
2.	Press and hold the Light button on the door

SECURITY'I"

Figure 2

SECURITY,I,

Garage Door Opener

	control.
3.	Press and hold the door control push button.
4.	After the opener light flashes, release all buttons.
Test by pressing the remote push button.

ff you do not have a Premium Control Console:

1.Press and holdthe selected remote control push button. See Figure 1.

2.Then press and release the SRT (leam) button on the back panel of the opener, Figure 2. The indicator light on the panel will begin to blink and the opener light will flash once.

3. Release the remote push button.

Test by pressing the remote push button.

To Erase All Remote Control Codes

Press and hold the SRT button on the opener panel

until the indicator light turns off (about 6 seconds). All remote control codes are now erased. Then follow

the steps above to re-program each remote control.

Remote Control

3-Function

.,._O0000tl_• SRT(leam) Indicator BACK

Button Ught PANEL

IISO tocatod OIt the opllner _

To Control the Opener Light (Premium Consoles) With SECURITY.Ik remote controls, a push button can be programmed to operate the opener light without opening the door.

1.With the door closed, press and hold the remote button that you want to control the light.

2.Press and hold the Light button on the door control.

3.Press and hold the Lock button on the door control.

4.After the opener light flashes, release all buttons.

Test by pressing the remote push button. The opener light should turn on or off but the door should not move.