Craftsman 139.53677SRT1, 139.53671SRT1, 139.53674SRT, 139.53661SRT1 Hang the Opener, 0SH=OCSlU,G

Installation Step 5	I
Hang the Opener

Two representative Installations are shown. Yours may be different. Hanging brackets should be angled, Figure 1, to provide dgid support. On finished ceilings, Figure 2, attach a sturdy metal bracket to structural supports before installing the opener. The bracket and fastening hardware are not provided. See accessory page 38.

•Measure the distance from each side of the opener to the structural support.

•Cut both pieces of the hanging bracket to required lengths.

•Drill 3/16" pilot holes in the structural supports.

•Attach one end of each bracket to a support with 5/16"-18xl -7/8"lag screws.

•Fasten the opener to the hanging brackets with 5/16"-18x7/8" screws, lock washers and nuts.

•Check to make sure the T-rail is centered over the door (or in line with the header bracket if the bracket is not centered above the door).

•Remove the 2x4. Operate the door manually. If the door hits the rail, raise the header bracket.

Figure I

_StructuraJ

5/16 -18xl -7/8"

Measure .__,

5/16"-18x7/8" Screw

5/16" Lock Washer

5/16".18 Nut

Figure 2

Grease the top and underside of the rail surface where the trolley __,_ slides. A tube of grease is _-__supplied.

	Hidden .		.	o....°	o-"" "'"
	SupDort				...;-:::-
	o,..-
.....	"" _	..;-;'.;;"'°"--_.0SH=OCSlU,G--
"" °	- "".'..- ° ""				Lag Screws •	..-"
..-'_				5/16"-18X1-?/8
SupportSra_dxet_		_			_'"	5/ (Not Prodded)
Not Provided)	_.\_,			..°-:.°-	_	16"-18x7/8 Screw
5/I 6"-I 8X7/8" Scte_					_	_---_..-

Hardware Shown Actual Size

5/16"18xl-7/8"

11111111111111111,llD

5/16"- 18X7/8" Nut 5/16"-18 LockWasher 5/16"

17