Craftsman 139.53610, 139.53403 owner manual Radio Controls, Transmitter, Receivertransmitter

Radio Controls

Your 3-channel transmitter(s) will operate more than one garage door opener, if desired, Also, refer to the catalog packed with your opener for remote light products which can be operated by the additional push buttons on the transmitter(s).

Instructions are given below for changing codes and/or using the transmitter(s) with additional receivers,

PLEASE KEEP THIS INSTRUCTION MANUAL HANDY FOR FUTURE REFERENCE.

SETTING/CHANGING YOUR CODE IN RECEIVER(S) AND TRANSMITTER(S)

_DISCONNECT POWER TO OPENER(OR OTHER

DEVICES) BEFORE SETTING OR CHANGING

THE CODE IN THE RECEIVER(S),

The TOP(Large) transmitter push button has been factory preset to operate the garage door opener. Each push button is programmed to operate by sliding RECEIVER code switch ##1 to a specific position (+, - or O). Detailed instructions are given below°

1_ Decide which transmitter push button you want to use to operate a receiver

2.Remove screw on back of transmitter(s)_ Carefully turn case over (push button side up),

3, Remove case top, CAUTION: Be careful not to move circuit board components_

4. Locate the RECEIVER code switch block

0TO USE TOP (LARGE) TRANSMITTER BUTTON: Set RECEIVER code switch I to minus (-).

@ TO USE CENTER TRANSMITTER BUTTON: Set RECEIVER code switch I to center(O)

© TO USE BOTTOM TRANSMITTER BUTTON: Set RECEIVER code switch 1 to plus (÷)

TO SETTH E CODE, use a pen or screwdriver Begin with code switch 2 on the RECEIVER. Slide one or

more of the switches to plus, minus or center(O) Hold transmitter(s) alongside receiver code switch Set code switches 2 through 9 in transmitter(s) to match receiver switch positions.

NOTE: Code switches 2 through 9 on ALL the

receivers operated by the transmitter(s) must MATCH switches 2 through 9 in transmitter(s). CAUTION: If you press more than ONE push but-

ton at the same time, transmitter will not operate.

TRANSMITTER

TOP(Large)

Push Button

CENTER

Push Button

BO3TOM

Push Button

RECEIVER

Code Switch No, I

1

Transmitter

Bottom Push Sutton _

Transmitter 0

Center Push Button

Transmitter _==

TOP Push Button

Code

Switches --

.1=123456789

RECEIVERTRANSMITTER

19