Assembly
TO AVOID INSTALLATION DIFFICULTIES, DO NOT RUN THE GARAGE DOOR OPENER UNTIL YOU ARE
INSTRUCTED TO DO SO.
ST _: P "1 Assemble Tee Rail & Attach Cable Pulley Bracket
TEE RAIL BACK
(TO CHASSIS)
CAUTION: Do not tighten the lock nuts until bolt necks are seated in square holes.
Tee Rail
(End Section)
t/4' Lock Nut
Tee Rail
The center rail section MUST be positioned on the LEFTSIDE of end rails as shown,
Otherwise, trolley will hit against nut when installed (Pg. 7).
Brace
Tee Rail
(End Section)
Square Carriage
Bolt Hole
Cable pulley bracket attaches to FRONT END of Tee Rail
TEE RAIL FRONT
(TO DOOR)
Carriage Bolt
/2"
Brace_
PROCEDURE: Place the 3 Tee rail sections on a flat
surface for assembly. THIS IS IMPORTANT. The end sections are identical. THE CENTER SECTION MUST BE POSITIONED WITH THE BRACES ON THE LEFT SIDE OF END SECTIONS. If there is a label attached to the cen-
ter section, make sure that the "directional arrow" is pointing toward the front (to door) Otherwise, study the illustration CAREFULLY
(When assembled, Tee rail has a
Bolt rail sections together with the hardware illus- trated and from the direction indicated
SQUARE NECKS ON CARRIAGE BOLTS MUST BE SEATED IN SQUARE HOLES IN RAIL SECTIONS,
Screws
_ _5/16"_18x7/8""
Cable Pulley | _ | _,_'; |
5/16"
5/16"
Position cable pulley bracket on front end of tee rail as shown. Fasten securely with the hardware provided
IMPORTANT: Whentighteningscrews, besureto
keep bracket parallel to rail, Otherwise, rail may bow when opener is operated.
6