TurboBrush®
(Available on select models only)
Assembly
Unplug cleaner from the outlet before attaching TurboBrush. Attach TurboBrush to the flex hose by pressing tool onto the grip/trigger until button snaps into hole. Make certain tool is securely in place.
Use
Move the TurboBrush switch to the “BRUSH” position.
1. This activates the brush when the unit is running.
Place the tool directly on the soiled surface. Apply
2. downward pressure on the tool and pull towards you while pulling trigger to spray cleaning solution.
Release the spray trigger and move the switch to the
3. “SUCTION” position. Vacuum the area until no more cleaning solution can be removed.
Repeat steps
4. Caution: Do not overwet.
When You’re Done
Disconnect the TurboBrush from the flex hose by pushing
1. down on the button lock and pulling straight off.
Once removed from the flex hose, the TurboBrush can be
2. cleaned.
A)Move the switch to the “SUCTION” position
B)Rinse under running water.
C)Check spray nozzle for dirt. If necessary, clean with a soft bristle brush.
D)Replace TurboBrush in its special storage
location on the handle front. (on select models only
SUCTION BRUSH
13