Troubleshooting Continued
DirtLifter PowerBrush does not turn.
Possible Causes | Remedies |
The Brush Belt or Pump Belt is off or broken.
Carpet Protector is not spraying.
Turn the machine OFF and unplug from the outlet. To check if a Pump Belt has broken, you will need a flat head screwdriver. Insert the blade end into the lower slot of the Belt Access door to release the lower snap. If necessary, insert the blade end into the upper slot to release the upper snap. Examine the belt for breakage. If broken refer to pages
Possible Causes | Remedies | |
Bottle not connected | Follow instructions on cartridge |
|
properly to the tool. | assuring proper fit. | |
Solution clogging the | Soak applicator tool only in hot water. | |
Spray trigger. | Spray without the cartridge attached to | |
| purge any residual Solution left in | |
| the tool. | |
Applicator tool spray is blocked.
Soak applicator tool only in hot water. Spray without the cartridge attached to purge any residual Solution left in
the tool.
SmartMix not set on water/rinse | Set to proper setting. |
carpet protector setting. |
|
ReadyTool dial not set on tool setting. Set to tool setting.
Cleaner not picking up solution. |
|
|
Possible Causes | Remedies |
|
Ready Tools dial may be at the | Set ReadyTools dial to either Tools or | |
wrong setting for the cleaning job. | PreTreat or Floor Cleaning. | |
Nozzle Window may not be | Press down firmly on the black oval | |
properly attached. | gasket at the top window to make sure | |
| the two tabs on the back of the Nozzle | |
| Window are snapped into the mating | |
| slots in the main housing. | |
Poor tool position.
(Hand held attachments only).
Adjust angle; apply more downward pressure.
Empty
21
