Special Features of your BISSELL ProHeat
The BISSELL SmartClean® System
The ProHeat is a home cleaning system that automatically mixes hot tap water with Fiber Cleansing Formula and heats the
solution as it is applied to the carpet. The combination of heated cleaning solution, powered brush and suction provide a safe and effective method of cleaning.
SmartTemp®
Temperature control automatically heats the cleaning solution as it is being applied to the carpet (*) to safely optimize cleaning effectiveness.
The Power Switch controls power to the machine; both
1. switches must be ON for SmartTemp to work.
The SmartTemp Switch is found on the back of the handle
2. next to the Power Switch. You may choose not to use the SmartTemp feature if you are cleaning delicate wool or oriental rugs.
*SmartTemp heats the cleaning solution for carpet and bare floor application only. It does not heat solution sprayed through the accessory tools.
The SmartTemp Ready Light indicates when the heater is
3. ON. The heater should be turned on two minutes before cleaning, to become fully warmed up and ready for cleaning. It is found on the front of the handle where it is easy to see while you clean.
SmartTemp increases the water temperature approximately
4. 25° and will not allow it to exceed 180.°
SmartMix®
Provides custom control for each cleaning job.
Lift the SmartMix concentrate bottle up and out of the
1. machine base.
Turn the bottle over so that the valve cap is in an upward
2. position. Unscrew the valve cap and fill the bottle to the mark with BISSELL Fiber Cleansing Formula.
| Replace the valve cap turning until snug. |
3. |
6
SmartTemp Ready Light
Power Switch
SmartTemp
Switch
ON
SmartMix bottle 
