Note: Both the SmartMix Bottle and the clean water tank must have liquid in them in order for the machine to spray. If one tank is empty the machine will not apply either cleaning solution or water only.
When It’s Time to Empty Tank-in-Tank
Lift the Tank-in-Tank handle. The handle locks the
2. lid in place.
3. Carry it like a bucket to fill at the sink.
Note: You may notice hair and debris deposits on
the carpet that were loosened by the brushing action (especially with newer carpets that have never been deep cleaned before). This debris should be picked up and thrown away. Debris that deposits in the Brush Belt should be cleaned between uses to keep the Belts running free.
Set the tank down and rotate the handle forward to
4. unlatch the lid. Lift off and set the lid aside.
Find the mouth of the Bladder and fill to the bottom of
5. the neck with clean hot tap water. *Do not boil or microwave water as it can destroy the Bladder.
Note: Fill the Bladder with clean hot tap water only.
Lift and Carry
3
4
Rotate Handle to Unlatch
6. | Replace the tank lid matching the lid and tank edges. |
| |
Handle must be in the forward position to reinstall. |
| ||
| Rotate the handle to the carrying position to | 5 | |
7. | Fill bladder only with | ||
the lid. | |||
clean hot tap water | |||
|
| ||
8. | Replace tank in machine base, seating firmly in place. |
| |
9. | Rotate handle back down to the latched position. |
|
9
Latched
Remove the Tank-in-Tank – follow steps 1 and 2
1. on page 7 and 8.
Carry the Tank-in-Tank, like a bucket, to the sink where
2. you will dispose of the dirty water.
8
