Assembly
STE P 4 I.stallChainandCable
DO NOT REMOVE CHAIN AND CABLE FROM CARTON
Detach cable from side of carton and fasten to trolley with a master link from coin envelope
MASTER LINK PROCEDURE: Push pins of master link bar through loop of cable and hole in flat end of trolley shaft (A) Push cap over pins and onto notches. Slide
Caution: Keep chain taut while installing to help prevent kinking,
With trolley against the screwdriver, dispense cable around pulley Proceed back around opener sprocket
(B)- be sure sprocket teeth engage chain - and forward to chain retainer bracket (C).
Use second master link to connect chain to retainer bracket. Check to make sure chain is not twisted.
I=!
install Chain andCable inThisDirection
Opener Chassis
Sprocket/
C
Th_reo_rde_dsEhndTee Rail | _ | j | Chain |
A
Master
Link
Spring
Retaai_eetr ear
End Trolley
Master
Link
Outside
Bar
Pulley
Install Chain and Cable
in This D{recl[on | Trolley |
As a permanent trolley stop, insert 5/16" washered screw and nut into remaining hole in Tee rail front Tighten securely REMOVE SCREWDRIVER.
TabPlate
Slot
St°P_H¢_ 5S/'Cr6ewWaan'hruetd
\
Remove
Screwdriver
Attach sprocket cover to chassis as shown, Insert back tab in chassis slot Then bend cover forward and
insert front tab in slot provided on mounting plate