Assernbiy
STE P 2 Install Trolley & Attach Chain Retainer Bracket
As a temporary stop, insert a screwdriver into hole in front end of Tee rail as shown. Slide the
inner trolley onto the Tee rail until it is firmly against the screwdriver
NOTE: If trolley hits against nut on Tee rail, center section was attached from wrong side and must
be repositioned. Review Step 1.
Slide the outer trolley onto the Tee rail until it partially
engages the inner trolley and stops
TO FULLY ENGAGE TROLLEY: With a hammer,
firmly tap the back end of outer trolley just below the rail guide Outer trolley must move forward to fully
Outer Trolley
Inner Trolley
engage inner trolley Be careful to avoid damaging trolley spring,
|
|
| Outer | |
|
|
| Nut | |
|
| Lock Washer | ._5/16" | |
|
| 5/16" | r | |
Temporary | Stop | Inner |
| |
Nut |
| |||
Screwdriver | Chain | |||
| ||||
|
|
| Retainer | |
Cable |
|
| Bracket | |
|
|
| ||
Pulley |
|
|
| |
Bracket |
| Threaded |
|
\ | End |
|
Trolley
Shaft
Flat End
Attach inner nut, lock washer, chain retainer bracket and outer nut to trolley shaft in the order shown_ DO NOT TIGHTEN NUTS UNTIL STEP 5, PAGE 9,
STE P 3 Attach Tee Rail to Opener Chassis
USE ONLYTHOSE SCREWS MOUNTED
IN TOPOFOPEN ER CHASSIS. FAILURE
TO DO SO WILL CAUSE SERIOUS DAM- AGE TO THE DOOR OPENER°
PROCEDURE: | Place opener chassis on packing | ||
ma terial to protect | cover For convenience, | place a | |
support under the cable pulley bracket |
| ||
Re move | washered screws | mounted |
in top of opener chassis Align holes in back end of Tee ran with holes in opener chassis. Fasten the rail
to the chassis with washered screws previously
removed. | CAUTION: | USEONLYTHESESCREWS! | ||||||
Use | of | any | other screws will | cause | serious | dam- | ||
age | to | door | opener. | Tighten | screws | securely, | ||
insert | a |
| washered screw into | trolley |
stop hole in the Tee rail as shown, Tighten securely with a 5/16" nut
Washered Screw
Stop Hole
Tee Rall
(Back Sectior
7