Craftsman 139.53403, 139.53610 owner manual Having a Problem?, Situation Probable Cause & Solution

Page 20

Having a Problem?

SITUATION

PROBABLE CAUSE & SOLUTION

OPENER DOESN'T OPERATE FROM EITHER WALL PUSH SUTTON OR TRANSMITTER

1.Have you disengaged all door locks? Review Step 8, Page 14

2.Does the opener have electric power? Plug a lamp into the outleL If it doesn't light, check fuse box or circuit breaker (Some outlets are con- trolled by a wall switch).

3.Repeated operation may have tripped the overload protector in the motor. Wait 15 minutes Try again

4.Is there a build-up of ice or snow under door? Door may be frozen to ground. Remove any obstruction

5.Remove bellwire from opener terminal& Touch red and white screw ter- minals together with ajumper wire If opener runs, check for a faulty wire connection at wall push button or a short under staples.

OPENER OPERATES FROM

TRANSMITTER BUT NOT FROM

WALL PUSH BUTTON

DOOR OPERATES FROM

WALL PUSH BUTTON BUT NOT FROM THE TRANSMITTER

TRANSMITTER HAS

SHORT RANGE

THE GARAGEDOOROPENS AND CLOSES SYITSELF

DOOR DOESN'TOPEN

COMPLETE_

DOOR DOESN'T CLOSE

COMPLETELY

1.Is wall push button lit? If not, refer to No. 5 above and follow same procedure.

2_ Are wiring connections correct? Review Step 6, Pg,13.

1Does the battery test light glow when transmitter push button is pressed? If not, replace the battery (Page 5 tells you how.)

2If you have two transmitters and only one operates, review code setting

procedures on Page 19 Receiver and ALL transmitters must be set to same code_

&Is transmitter(s) operating additional remote control devices? See code setting procedures on Page 19

4.Did you press transmitter button designated to operate garage door opener?

5Re-program receiver(s) and ALL transmitters, Try setting ALL the code switches in plus, center or minus positions. If transmitter(s) works, you can try a random code switch setting again, if you desire.

1_ Check battery test light If the light is out, change the battery(Page 5 tells you how).

2. Change the location of transmitter in the car.

3 A metal garage door, foil-backed insulation or metal siding will reduce transmission range.

4.Check to be sure the antenna on the back panel of the opener extends fully downward.

1Isthere a neighborwith a garage door opener using the same frequency code? Change your code Review Page 19.

2.Check to makesure that the transmitter push button(s) is not stuckin the 'down'position

3.Remove bell wire from opener terminals and operate from transmitter only If this solves the problem, the wall push button is faulty (replace), or there is a short or broken wire between push button and opener

1.Is something obstructing the door?

2.If door opens at least 5 feet, travel limits may need to be increased One turn equals 2 inches of travel See Pg 17. Repeat Safety Reverse Test after adjustment is complete

3.If door has been working properly but now doesn't open all the way, increase UP FORCE See Pg. 17 Repeat Safety Reverse Test after adjust- ment is complete

1.Review the Travel Limits Adjustment Chart on Page 17. Repeat Safety Reverse Test after any adjustment of door arm length, close force or

down limit.

2o

Page 19 Page 21
Image 20
Page 19 Page 21
Contents 3953606 Features of Your Opener SpecificationsAssembly Hardware Installation Carton Check ListYoull Need Tools LinkLocks to avoid damage to garage door Start By Reading These Impo ant Safety RulesDisengage ALL Existing Garage Door Check Chain TENSION. Adjust if necessary Replace the Transmitter BATTERY, preferably be- fore winterOperation of Your Opener Care of the OpenerTee Rail AssemblyST P 1 Assemble Tee Rail & Attach Cable Pulley Bracket Assernbiy STE P 3 Attach Tee Rail to Opener ChassisTo Fully Engage Trolley With a hammer To the chassis with washered screws previouslyTabPlate Pulley Install Chain and CableLink STE P 5 Tighten Chain and CableMAY Find IT Garage Door OpenerInstallation STE P 1 Position & Install Header BracketSectional Door ExampleSTE P 2 A.ach Tee Rail to Header Bracket 16 x2-3/4Hang Opener Chassis STE P 5 Attach EmergencyRelease Rope & Handle Checkto make sure Tee rail is centered over doorWiring Instructions for Accessories TopFtange Infrared Reversing SystemLighl Lensab75LightWattBulbMaX STE P 7 Install Light and LensProcedure Refer to illustration Make connec Nut STE P 9 Install Door Bracket and PlateReinforcement Installation only Door InstallationsAdjustment Procedures STE P 10 Connect Door Arm to TrolleyAdjustment Adjust ForceLimit Adjustment Chart Force Adjustment ChartTest Safety Reverse System Sectional DoorRadio Controls TransmitterReceivertransmitter ReceiverHaving a Problem? Situation Probable Cause & SolutionSituation Probable Cause & Solution Door Wont CloseDoor Travel Doesnt Turn OFFRepair Parts RAI L Assembly Parts ListKEY Part DescriptionRepair Parts Chassis Assembly Parts List KEY Part DescriptionWasher RetainingHOW to Order Repair Parts Full DAY Warranty On Garage Door OpenerLimited Warranty Limitation on Liability

139.53610, 139.53403 specifications

The Craftsman 139.53403 and 139.53610 are two innovative garage door openers that have gained popularity among homeowners for their advanced features, reliability, and ease of use. Both models are designed to enhance the convenience and security of managing garage doors, making them indispensable tools for modern homes.

One of the standout characteristics of these Craftsman garage door openers is their powerful motors. The 139.53403 is equipped with a 1/2 horsepower motor, while the 139.53610 features a robust 1/3 horsepower motor. Both motors provide ample power to ensure smooth and efficient operation, accommodating most residential garage doors with ease. This capacity is vital for longevity and performance, especially in varying weather conditions.

In terms of technological advancements, both models incorporate innovative myQ technology, which allows users to control their garage doors remotely through a smartphone app. This feature not only offers unparalleled convenience, allowing homeowners to open or close their garage doors from anywhere, but also enhances security by providing alerts and status updates. The integration of smart technology represents a shift towards greater connectivity and automation in everyday tasks.

Safety features are another significant aspect of these openers. Both the 139.53403 and 139.53610 are built with safety reversing sensors that detect obstacles in the door's path, ensuring that the door will reverse if something is in the way. This feature is crucial for preventing accidents, particularly in households with children or pets.

Installation of these models is designed to be user-friendly, with many customers reporting that they were able to set them up in less than an hour. The clear instructions and included hardware make the process straightforward, so even those with minimal DIY experience can successfully install their garage door openers.

Additionally, both models are compatible with a variety of garage door styles, making them versatile options for different homes. Their durable construction promises to withstand the rigors of daily use, ensuring that they will be a lasting investment.

In summary, the Craftsman 139.53403 and 139.53610 garage door openers offer a compelling combination of power, smart technology, safety features, and ease of installation. These characteristics make them a solid choice for homeowners looking to enhance the functionality and security of their garages while enjoying the convenience of modern technology.
Top Page Image Contents