Mitsubishi Electronics PAC-YG63MCA instruction manual Electromagnetic Compatibility Directive

Page 16

This product is designed and intended for use in the residential,

commercial and light-industrial environment.

This product at hand is

Low Voltage Directive 2006/95/EC

based on the following

Electromagnetic Compatibility Directive

EU regulations:

 

2004/108/EC

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

HEAD OFFICE: TOKYO BLDG., 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN

WT04975X02 Printed in Japan

Image 16
Contents AI controller Safety Precautions Include some slack in the power supply wiresSpecifications Device Specifications Parts ListUsage External Dimensions Example of System ConfigurationInstallation Parts Purchased Separately Installation Instructions Wiring Instructions 7-1. Terminal Diagram Top of the control panel toTerminal block FireConnecting the Power and M-NET Transmission Lines NETConnecting the Sensors Connecting Alarm Setpoint Outputs Non-valtage Contacts Initial Settings Ch1 Dip Switch Functions Supported FunctionSensor and Communication Error Displays Alarm Setpoint Output and Error DisplaysLED Display Designations System Operation Test Electromagnetic Compatibility Directive