Clarion DXZ645MP Adjusting the display contrast, Anti-theft indicator, Setting LOW Pass Filter

Operations Common to Each Mode

Dimmer control Setting the sub woofer

You can setting the dimmer control “ON” or “OFF”.

∗The factory default setting is “ON”.

1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.

2.Press the [a] or [d] button to select “DIMMER”.

3.Turn the [ROTARY] knob clockwise to “ON” or counterclockwise to “OFF”.

4.Press the [T] button to return to the previous mode.

You can set the sub-woofer on or off.

∗The factory default setting is “ON”.

1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.

2.Press the [a] or [d] button and select “SUB-WOOFER”.

3.Turn the [ROTARY] knob clockwise to “ON” or counterclockwise to “OFF”.

4.Press the [T] button to return to the previous mode.

English

Adjusting the display contrast

You can adjust the display contrast to match the angle of installation of the unit.

∗The factory default setting is “8”. (Adjustment level: 1 to 16)

1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.

2.Press the [a] or [d] button to select “CONTRAST”.

3.Turn the [ROTARY] knob clockwise or coun- terclockwise to adjust the contrast.

4.Press the [T] button to return to the previous mode.

Anti-theft indicator

The red Anti-theft indicator is a function for pre- venting theft. When the DCP is removed from the unit, this indicator blinks.

∗The factory default setting is “OFF”.

1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.

2.Press the [a] or [d] button and select “BLINK LED”.

3.Turn the [ROTARY] knob clockwise to set this function “ON” or turn it counterclockwise to switch this function “OFF”.

4.Press the [T] button to return to the previous mode.

Setting LOW PASS FILTER

∗If sub-woofer function is set “ON”, “LOW PASS FIL- TER” can be selected.

∗The factory default setting is “LPF THRGH”.

1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.

2.Press the [a] or [d] button to select “SUB-W LPF”.

3.Turn the [ROTARY] knob clockwise or coun- terclockwise to select the setting. Each time you turn the [ROTARY] knob, the setting changes in the following order:

LPF THRGH ➜ LPF 50Hz ➜ LPF 80Hz ➜

LPF 120Hz

4.Press the [T] button to return to the previous mode.

Selecting AUX IN sensitivity

Make the following settings to select the sensi- tivity when sounds from external devices con- nected to this unit are difficult to hear even after adjusting the volume.

∗The factory default setting is “MID”.

1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.

2.Press the [a] or [d] button to select “AUX SENS”.

3.Turn the [ROTARY] knob clockwise or coun- terclockwise as needed and select from “HIGH”, “MID” or “LOW”.

4.Press the [T] button to return to the previous mode.

DXZ645MP 23