Electro-Voice EVH-1152S, EVF-2121S, EVF-1152D Six-enclosure horizontal hang of three systems above

Page 34

5.0 EVF and EVH Rigging System (cont’)

 

Figure 23b:

Figure 23a:

A six-enclosure horizontal hang of three systems above and

three systems below, connected by four HRK-2 kits

A six-enclosure horizontal hang

(optional accessories) and user-supplied hardware to

of three systems above and three

link both clusters, using a more extreme trim angle

systems below, connected by four

 

HRK-2 kits (optional accessories)

 

and user-supplied hardware to

 

link both clusters, using a

 

moderate trim angle

 

Figure 23c:

A six-enclosure horizontal hang of three systems above and three systems below, connected by four HRK-2 kits (optional accessories) and user-supplied hardware to link both clusters, using an extreme trim angle

34

Electro-Voice EVF/EVH User Manual

Image 34 Contents
Page Table of Contents Table of Contents cont’ Rigging-Safety WarningIntroduction Introduction cont’ EVF-1122S/96 exampleEnd View Front View Side View 143.0 lb 64.9 kg 145.5 lb 66.1 kg Key suspension point dimensions as shown in figure above DimensionEVF Front-Loaded Series Finishes and Colors AvailableEVH Horn-Loaded Series Accessories for EVF and EVH Systems Tool ListDesigning an EVF/EVH Cluster General Aiming and Placement GuidelinesDirectivity Break Frequency Defined Designing an EVF/EVH Cluster cont’ Basic Clustering GuidelinesCoverage-Uniformity Target Multiple-Source Interference in Clusters Normalized See text for more detailsReducing Multiple-Source Interference EVF Full-Range Designing an EVF/EVH Cluster cont’ Recommended Preflight Procedures Preparing EVF and EVH Systems for InstallationPassive/Biamp Crossover Configuration Preparing EVF and EVH Systems for Installation cont’ Rotation of High-Frequency Waveguides EVF systemsDigital Signal Processing Full-Range Systems in Passive Mode Preparing EVF and EVH Systems for Installation cont’ VRK-1 or HRK-1 connection VRK-2 or HRK-2 connection EVF and EVH Rigging SystemIntroduction Flying EV-Innovation EV-I Loudspeaker System VRK-1 or HRK-1 connectionVRK-2 rigging kit with parts identified EVF and EVH Rigging System cont’VRK-1 rigging kit with parts identified VRK-3 rigging kit with parts identifiedHRK-2 rigging kit with parts identified HRK-1 rigging kit with parts identifiedHRK-3 rigging kit with parts identified Important Details that Apply to the VRK and HRK Rigging Kits EV-I Rigging PrimerEVF and EVH Rigging System cont’ Eyebolt Installation Hardware not shown, using a All-Eyebolt ClustersTwo-system horizontal cluster using Systems, using an extreme trim angle Systems, using a moderate trim angleVRK Kits and Vertically Rigged Clusters HRK Kits and Horizontally Rigged Clusters EVF Full-Range Six-enclosure horizontal hang of three systems above Assembly Instructions for VRK and HRK kits Short in front Toward grille Rigging-Strength Ratings and Safety Factors Working Load Limit and Safety-Factor DefinitionsRigging-Strength Ratings and Safety Factors cont’ Structural Rating OverviewLimits for ALL-EYEBOLT Clusters only All-Eyebolt Structural RatingsWorking Load Limits for Eyebolts WLL for M10 eyebolts in the EVI-M10K eyebolt kitSuspension-Line Angles Left-to-Right All-Eyebolt Cluster AnglesVRK Rigging Structural Ratings for Vertical Clusters Limits for Vertical Clusters only WLL for M10 eyebolts in the EVI-M10K eyebolt kit Left-to-Right Vertical Cluster Angles HRK Rigging Structural Ratings for Horizontal Clusters Maximum load and maximum height for horizontal clustersUsing Tie Plates as Main Load-Bearing Suspension Two cluster using HRK rigging kitsSuspension-Line Angles for HRK Kits Symmetry for Horizontal Clusters using HRK Kits Inner Connection Points Left-to-Right Horizontal Cluster AnglesElectro-Voice Structural-Analysis Procedures Ratings for Outdoor Applications with Wind LoadingRigging Inspections and Precautions Mechanical Engineering printed ReferencesRigging printed Rigging Web sitesPage Page Electro-Voice
Related manuals
Manual 2 pages 29.71 Kb