Electrolux EFC 9673 Grease and charcoal filter maintenance indicator, EFC 9670-9671-9673

Grease and charcoal filter maintenance indicator

This hood is fitted with a device that indicates when it is necessary to clean the grease filter or the charcoal filter (if the hood is used in the recirculation version with a charcoal filter).

EFC 9670-9671-9673- 6670

On delivery, the hood is not supplied with a charcoal filter, so the saturation indicator will be disabled.

If the hood is to be used with a charcoal filter (EFC 90670-60670:the hood is supplied with a charcoal filter), the saturation

indicator light must be enabled as follows:

Set in "OFF" the hood.

Press buttons 4 and 5 simultaneously and hold them for 3 seconds. At first only the grease filter LED F will light up, but when the charcoal filter LED C lights up the saturation indicator will be enabled.

To disable it: Press buttons 4 and 5 again simultaneously and hold them for 3 seconds, until the charcoal filter LED goes out.

electrolux control panel 11

Grease filter LED (F)

LED F will start to flash when it is time

to clean the grease filter.GB Cleaning will be necessary after 40 working hours. Always comply with the maintenance instructions for the grease filter.

Charcoal filter LED (C)

The charcoal filter LED C will start to flash when the charcoal filter needs to be replaced.

This operation is necessary after approximately 160 working hours.

Resetting the saturation indicator

After cleaning or replacing the filters, press button 5 for 3 seconds until the grease filter LED F or the charcoal filter LED C stops flashing.