Electrolux E40PV100FS installation instructions Fuse Replacement

Page 10

FUSE REPLACEMENT

FUSE/S

Figure 3

IF LIGHTS FAIL TO OPERATE, DISCONNECT POWER AT THE SERVICE ENTRANCE. CHECK THE FUSE AND REPLACE IF NECESSARY.

1Remove grease ﬁlters.

2Remove the electrical box support and open the fuse box.

3 Unscrew the cap from the fuse holder and remove the fuse.

4Replace the fuse with the same size and amperage (5 x 20mm, 4 amp, 125 volt).

CAUTION

5Reconnect power at the service entrance.

Image 10

Contents Use & Care Guide Installation Instructions QUESTIONS? Finding InformationRead and Save These Instructions 877- 4ELECTROLUXTable of Contents Safety Important Safety InstructionsSafety Precautions Safety Safety Operating Your Hood Getting StartedAuto-Start Heat Sensing System Halogen Bulbs OperationBulb may be hot Fuse Replacement Use of a fuse greater than 4 amps may damage the transformerHood Cleaning Care and CleaningCleaning the Filters and Hood Grease FiltersInstallation Installation PlanningVerify Package Contents Installing the Ductwork To reduce the risk of ﬁre, use only metal ductworkInstalling the Support System Installation15Requires optional 10-foot ﬂue extension model EXPV100S Connecting the Decorative Flue Installing the Duct CollarInstalling the Electrical Mounting the Hood to Support FrameConnecting the Ductwork Replacing the Bottom TrimInstalling the Filters Prior to use, remove protective ﬁlm from the ﬁlter frameTroubleshooting If Service is RequiredTroubleshooting Guide Problem Possible Cause RemedySaving Energy Energy Saving TipsPage Warranty Hood Warranty Your hood is protected by this warranty