Electrolux E40PV100FS installation instructions Connecting the Ductwork, Replacing the Bottom Trim

Page 18

CONNECTING THE DUCTWORK

LOWER

FLUE

RETAINING

SCREWS

MOUNTING SCREWWS (3.9 x 9.5 mm)

Figure 15

1Use 8” round metal duct to connect the discharge collar on the hood to the ductwork above.

2Use duct tape to make all joints secure and air tight.

3Remove the two temporary retaining screws from the lower ﬂue and set it in place on the hood.

4Secure decorative ﬂue to hood with two mounting screws (3.9 x 9.5mm). pan head mounting screws.

1Remove the four (4) screws from the inside of the hood.

2 Remove the trim by pulling downward.

3 Slide the new trim upward into hood.

4 Replace the four screws inside hood.

Figure 16

Image 18

Contents Use & Care Guide Installation Instructions QUESTIONS? Finding InformationRead and Save These Instructions 877- 4ELECTROLUXTable of Contents Safety Important Safety InstructionsSafety Precautions Safety Safety Getting Started Operating Your HoodAuto-Start Heat Sensing System Operation Halogen BulbsBulb may be hot Fuse Replacement Use of a fuse greater than 4 amps may damage the transformerHood Cleaning Care and CleaningCleaning the Filters and Hood Grease FiltersInstallation Installation PlanningVerify Package Contents Installing the Ductwork To reduce the risk of ﬁre, use only metal ductworkInstallation15 Installing the Support SystemRequires optional 10-foot ﬂue extension model EXPV100S Connecting the Decorative Flue Installing the Duct CollarInstalling the Electrical Mounting the Hood to Support FrameConnecting the Ductwork Replacing the Bottom TrimInstalling the Filters Prior to use, remove protective ﬁlm from the ﬁlter frameTroubleshooting If Service is RequiredTroubleshooting Guide Problem Possible Cause RemedySaving Energy Energy Saving TipsPage Warranty Hood Warranty Your hood is protected by this warranty