Electrolux E40PV100FS installation instructions Safety Precautions

Page 5

Safety 5

SAFETY PRECAUTIONS

WARNING

Read all instructions before using this appliance.

Install or locate this appliance only in accordance with these installation instructions.

Do not operate this appliance if it has a damaged electrical conduit or wires, if it is not working properly or if it has been damaged or dropped.

To reduce the risk of fire, electric shock, or injury to persons, observe the following:

a)Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction.

b)Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent back drafting. Follow the heating equipment manufacturer’s guidelines and safety standards such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.

c)When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.

d)Ducted fans must always be vented outdoors.

e)Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer.

f)Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

To reduce the risk of fire, use only metal ductwork.

Grounding Instructions

This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet this is properly installed and grounded.

Improper grounding can result in a risk of electric shock.

Consult a qualified electrician if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded.

Do not use this unit with any separate solid-state speed control device.

Image 5
Contents Use & Care Guide Installation Instructions Read and Save These Instructions Finding Information QUESTIONS? 877- 4ELECTROLUXTable of Contents Important Safety Instructions SafetySafety Precautions Safety Safety Auto-Start Heat Sensing System Getting StartedOperating Your Hood Bulb may be hot OperationHalogen Bulbs Use of a fuse greater than 4 amps may damage the transformer Fuse ReplacementCleaning the Filters and Hood Care and CleaningHood Cleaning Grease FiltersInstallation Planning InstallationVerify Package Contents To reduce the risk of fire, use only metal ductwork Installing the DuctworkRequires optional 10-foot flue extension model EXPV100S Installation15Installing the Support System Installing the Duct Collar Connecting the Decorative FlueMounting the Hood to Support Frame Installing the ElectricalReplacing the Bottom Trim Connecting the DuctworkPrior to use, remove protective film from the filter frame Installing the FiltersIf Service is Required TroubleshootingProblem Possible Cause Remedy Troubleshooting GuideEnergy Saving Tips Saving EnergyPage Hood Warranty Your hood is protected by this warranty Warranty