Electrolux E40PV100FS installation instructions Installing the Filters

Page 19

INSTALLING THE FILTER(S)

1To remove the grease ﬁlter, grip the latch and pull it down. This will disengage the ﬁlters from the hood. Tilt the ﬁlter downward and remove.

2 To install the grease ﬁlter, align rear ﬁlter tabs with slots in the hood. Pull latch tab down, push ﬁlter up into position and release the tab. Make sure the ﬁlter is securely engaged after installation.

NOTE

Prior to use, remove protective ﬁlm from the ﬁlter frame.

GREASE

FILTERS

Figure 17

Image 19

Contents Use & Care Guide Installation Instructions 877- 4ELECTROLUX Finding InformationRead and Save These Instructions QUESTIONS?Table of Contents Important Safety Instructions SafetySafety Precautions Safety Safety Operating Your Hood Getting StartedAuto-Start Heat Sensing System Halogen Bulbs OperationBulb may be hot Use of a fuse greater than 4 amps may damage the transformer Fuse ReplacementGrease Filters Care and CleaningCleaning the Filters and Hood Hood CleaningInstallation Planning InstallationVerify Package Contents To reduce the risk of ﬁre, use only metal ductwork Installing the DuctworkInstalling the Support System Installation15Requires optional 10-foot ﬂue extension model EXPV100S Installing the Duct Collar Connecting the Decorative FlueMounting the Hood to Support Frame Installing the ElectricalReplacing the Bottom Trim Connecting the DuctworkPrior to use, remove protective ﬁlm from the ﬁlter frame Installing the FiltersIf Service is Required TroubleshootingProblem Possible Cause Remedy Troubleshooting GuideEnergy Saving Tips Saving EnergyPage Hood Warranty Your hood is protected by this warranty Warranty