Electrolux FAVORIT 44080 i manual What to do if, Remedying small malfunctions

What to do if...

Remedying small malfunctions

If while the appliance is operating indicators on the control panel flash or are lit up as described in the following table, please consult this to find out how to remedy the fault.

After remedying the fault that is flashing in the first or second rhythm in the programme progress display, press the button for the dishwashing cycle that had already started. The cycle will continue. In the case of other fault messages:

–Cancel the dishwashing cycle.

–Switch the appliance off and on again.

–Select dishwashing cycle.

If the fault is displayed again, please contact the Service Force Centre and inform them of the fault message.

Malfunction	Possible cause	Remedy
	The tap is blocked or furred	Clean tap.
	with lime-scale.
	The tap is turned off.	Turn the tap on.
The programme indicator for	The filter (where present) in	Clean the filter in the
	the threaded hose fitting on
the selected dishwashing cy-	the tap is blocked.	threaded hose fitting.
cle is flashing,
the indicator for the end of		Cancel the dishwashing
the dishwashing cycle is		cycle (see chapter:
flashing in sequence 1 short	Filters in the base of the	Starting a dishwashing
light signal with approx. 3	washing compartment are	cycle),
second pause in-between:		clean filters (see chap-
	blocked.
(Problems with water inlet)		ter: Cleaning the filters),
		then start the dishwash-
		ing cycle again.
	Water inlet hose has not	Check hose installation.
	been correctly positioned.
The programme indicator for	The sink spigot connection	Clean the sink spigot
the selected dishwashing cy-	is blocked.	outlet.
cle is flashing,
the indicator for the end of
the dishwashing cycle is	Water drain hose has not	Check hose installation.
flashing in sequence 2 short
	been correctly positioned.
light signals one after anoth-
er.

25