Electrolux FAVORIT 44080 i manual Electrical Connection, Changing a fuse

Page 36

Electrical Connection

Any electrical work required to install this appliance should be car- ried out by a qualified electrician or competent person.

1 WARNING - This appliance must be earthed.

The manufacturer declines any responsibility should these safety measures not be observed.

Before switching on make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.

To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.

Changing a fuse

The appliance is supplied with a 13amp plug fitted. In the event of hav- ing to change the fuse in the plug supplied, a 13amp ASTA approved (BS 1363A) fuse must be used.

Should the plug need to be replaced for any reason, proceed as described below.

The wires on the mains lead are col- oured in accordance with the fol- lowing code.

Green & Yellow

Green and Yellow: Earth

Blue:Neutral

Brown:Live

Blue

Brown

Cord Clamp

•The wire coloured green and yellow must be connected to the termi- nal marked with the letter “E“ or by the earth symbol E or coloured green and yellow.

•The wire coloured blue must be connected to the terminal “N“ or col- oured black.

•The wire coloured brown must be connected to the terminal marked “L“ or coloured red.

•Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

1WARNING! A cut off plug inserted into a 13 amp socket is a seri- ous safety (shock) hazard. Ensure that, if it is necessary to cut off the plug, it is disposed of safely and not retained.

36

Image 36

Contents Favorit 44080 Following symbols are used in the text Dear CustomerContents Safety Prior to using for the first timeChild Safety General SafetyDiagram of Appliance Control PanelControl indicators have the following meanings Prior to Using for the First Time Setting the Water SoftenerSetting manually Setting electronicallySetting Only when using the dishwasher for the first time Adding dishwasher SaltFilling Up with Rinse Aid Setting the Amount of Rinse Aid Required Daily use Loading cutlery and dishesLoading cutlery Pots, Pans, Large PlatesCups, Glasses, Coffee Service Adjusting the Height of the Upper Basket Adding DetergentRaising / Lowering the upper bas- ket Concentrated detergents Detergent tabletsUsing 3in1 detergents If you want to use 3in1 productsIf you do not want to use 3in1 products any more If you want to use 4in1 productsSelecting the dishwashing cycle Cycle Table Suitable TypeSelecting a programme Interrupting or Cancelling a dishwashing cycle Setting the Delay TimerCancelling the wash programme Starting a Dishwashing CycleSwitching Off the dishwasher To change the time delayCancelling the delay timer Removing the DishesCare and cleaning Cleaning the filtersCleaning the spray arm jets Upper basket spray armBottom spray arm What to do if Remedying small malfunctionsIndicator for the end Dishwashing cycle is If the Dishwashing Results are not Satisfactory Dishes are still dirtyDishes do not dry and are not shining There are dried water drops on the glasses and dishesDisposal Packaging materialOld appliance Technical Data Example loading arrangements Full load Half loadPage Installation and connection instructions Safety Information for the InstallationInstalling the Dishwasher Dishwashers That Can be IntegratedConnecting the dishwasher Connecting to the water supplyConnecting the inlet hose Permitted water pressureWater drainage Anti-flood systemElectrical Connection Changing a fuseGreen and Yellow Earth BlueNeutral BrownLive Connecting systems Warranty conditions Great Britain0870 5 929 Customer Care For general enquiries concerningAEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG