Electrolux FAVORIT 44080 i manual Installation and connection instructions

Page 32

Installation and connection instructions

1Safety Information for the Installation

•Only transport the dishwasher in an upright position, otherwise salt water may run out.

•Before using the dishwasher for the first time, check for any damage caused in transport. Do not under any circumstances connect an ap- pliance that is damaged. In the case of damage, please contact your supplier.

•Never use the dishwasher if the mains cable, water inlet or drain hose are damaged; or if the control panel, work top or plinth area are damaged such that the inside of the appliance is freely accessible.

•Always plug the mains plug into a correctly installed shockproof socket.

•Permanent connection: a permanent connection must only be in- stalled by a trained electrician.

•Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the sup- ply where the appliance is to be installed. The fuse rating is also to be found on the rating plate.

•Multi-way plugs / connectors and extension cables must not be used. This could constitute a fire hazard through overheating.

•The dishwasher’s cable must only be replaced by a Service Force Engi- neer.

•A water inlet hose with safety valve must only be replaced by a Serv- ice Force Engineer.

32

Image 32

Contents Favorit 44080 Following symbols are used in the text Dear CustomerContents Safety Prior to using for the first timeChild Safety General SafetyDiagram of Appliance Control PanelControl indicators have the following meanings Prior to Using for the First Time Setting the Water SoftenerSetting manually Setting electronicallySetting Only when using the dishwasher for the first time Adding dishwasher SaltFilling Up with Rinse Aid Setting the Amount of Rinse Aid Required Daily use Loading cutlery and dishesLoading cutlery Pots, Pans, Large PlatesCups, Glasses, Coffee Service Raising / Lowering the upper bas- ket Adjusting the Height of the Upper BasketAdding Detergent Concentrated detergents Detergent tabletsUsing 3in1 detergents If you want to use 3in1 productsIf you do not want to use 3in1 products any more If you want to use 4in1 productsSelecting the dishwashing cycle Cycle Table Suitable TypeSelecting a programme Interrupting or Cancelling a dishwashing cycle Setting the Delay TimerCancelling the wash programme Starting a Dishwashing CycleSwitching Off the dishwasher To change the time delayCancelling the delay timer Removing the DishesCare and cleaning Cleaning the filtersCleaning the spray arm jets Upper basket spray armBottom spray arm What to do if Remedying small malfunctionsIndicator for the end Dishwashing cycle is If the Dishwashing Results are not Satisfactory Dishes are still dirtyDishes do not dry and are not shining There are dried water drops on the glasses and dishesOld appliance DisposalPackaging material Technical Data Example loading arrangements Full load Half loadPage Installation and connection instructions Safety Information for the InstallationInstalling the Dishwasher Dishwashers That Can be IntegratedConnecting the dishwasher Connecting to the water supplyConnecting the inlet hose Permitted water pressureWater drainage Anti-flood systemGreen and Yellow Earth BlueNeutral BrownLive Electrical ConnectionChanging a fuse Connecting systems Warranty conditions Great Britain0870 5 929 Customer Care For general enquiries concerningAEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG