Electrolux FAVORIT 44080 i manual Water drainage, Anti-flood system

Page 35

Water drainage

Drain hose

1 The drain hose must not be kinked, crushed or entangled. Connecting the drain hose:

Maximum permitted height: 1 metre.

Minimum required height: 40 cm above the bottom edge of the ap- pliance.

Extension hoses

Extension hoses are available from your local Service Force Centre. To

ensure that the function of the ap- pliance is not impeded, the internal diameter of extension hoses must be 19 mm.

• Extension hoses must not be laid more than a maximum distance of 4 metres horizontally; the maxi- mum permitted height for the con- nection for the drain hose is then 85 cm.

Sink outlet connection

The outlet of the drain hose (ø 19 mm) fits all commonly available sink outlet types. The outer diameter of the sink outlet connection must be at least 15 mm.

The drain hose must be fixed to the sink outlet connection using the hose clamp supplied.

Water drainage if the dishwasher is built-in at high level

If the dishwasher is installed at a high level, and the drain hose connec- tion is less than 30 cm from the lower edge of the appliance, adapter kit ET 111099520 must be fitted by your local Service Force Centre.

Anti-flood system

For protection from water damage, the dishwasher is equipped with a anti-flood system.

In the event of a fault, the safety valve in the water inlet hose immedi- ately interrupts the supply of water to the appliance and the drain pump is activated. In this way water can neither escape nor overflow. The remaining water in the appliance is automatically pumped out.

35

Image 35
Contents Favorit 44080 Dear Customer Following symbols are used in the textContents General Safety SafetyPrior to using for the first time Child SafetyControl Panel Diagram of ApplianceControl indicators have the following meanings Setting electronically Prior to Using for the First TimeSetting the Water Softener Setting manuallySetting Adding dishwasher Salt Only when using the dishwasher for the first timeFilling Up with Rinse Aid Setting the Amount of Rinse Aid Required Loading cutlery and dishes Daily usePots, Pans, Large Plates Loading cutleryCups, Glasses, Coffee Service Raising / Lowering the upper bas- ket Adjusting the Height of the Upper BasketAdding Detergent Detergent tablets Concentrated detergentsIf you want to use 4in1 products Using 3in1 detergentsIf you want to use 3in1 products If you do not want to use 3in1 products any moreSuitable Type Selecting the dishwashing cycle Cycle TableSelecting a programme Starting a Dishwashing Cycle Interrupting or Cancelling a dishwashing cycleSetting the Delay Timer Cancelling the wash programmeRemoving the Dishes Switching Off the dishwasherTo change the time delay Cancelling the delay timerCleaning the filters Care and cleaningUpper basket spray arm Cleaning the spray arm jetsBottom spray arm Remedying small malfunctions What to do ifIndicator for the end Dishwashing cycle is There are dried water drops on the glasses and dishes If the Dishwashing Results are not SatisfactoryDishes are still dirty Dishes do not dry and are not shiningOld appliance DisposalPackaging material Technical Data Full load Half load Example loading arrangementsPage Safety Information for the Installation Installation and connection instructionsDishwashers That Can be Integrated Installing the DishwasherPermitted water pressure Connecting the dishwasherConnecting to the water supply Connecting the inlet hoseAnti-flood system Water drainageGreen and Yellow Earth BlueNeutral BrownLive Electrical ConnectionChanging a fuse Connecting systems Great Britain Warranty conditionsCustomer Care For general enquiries concerning 0870 5 929AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG