Electrolux FAVORIT 44080 i manual Starting a Dishwashing Cycle, Setting the Delay Timer

Page 20

Starting a Dishwashing Cycle

1.Check that the spray arms can turn freely.

2.Turn the water tap on fully.

3.Close the door.

4.Press the ON/OFF button.

5.Select the desired cycle.

The programme display lights up. The selected cycle will begin after ap- proximately 3 seconds.

Interrupting or Cancelling a dishwashing cycle

Interrupt a dishwashing cycle that is in progress if it is absolutely nec- essary.

Interrupting the dishwashing programme by opening the dishwash- er door

1 Hot steam may escape when the door is opened. There is a risk of scald- ing.

1.Open the door carefully. The dishwashing cycle will stop.

2.Close the door. The cycle will continue.

Cancelling the wash programme

1.Press function buttons 2 and 3 and hold them down.

The LED indicators of all the programme buttons that can be selected will illuminate.

2.Release the function buttons. The wash programme has been cancelled.

3.If you want to start a new wash programme, check whether there is any detergent in the dispenser.

3 Turning off the dishwasher will only interrupt a selected dishwashing cycle, not cancel it. The cycle will recommence after turning the dish- washer back on again.

Setting the Delay Timer

Using the delay timer you can delay the start of a dishwashing cycle for 3, 6 or 9 hours.

1.Press the ON/OFF button.

2.Press the Delay Timer button repeatedly until the indicator next to the number of hours for which the start of the dishwashing cycle is to be delayed lights up, e. g. 6h, if the cycle is to start in 6 hours.

20

Image 20

Contents Favorit 44080 Following symbols are used in the text Dear CustomerContents Safety Prior to using for the first timeChild Safety General SafetyDiagram of Appliance Control PanelControl indicators have the following meanings Prior to Using for the First Time Setting the Water SoftenerSetting manually Setting electronicallySetting Only when using the dishwasher for the first time Adding dishwasher SaltFilling Up with Rinse Aid Setting the Amount of Rinse Aid Required Daily use Loading cutlery and dishesLoading cutlery Pots, Pans, Large PlatesCups, Glasses, Coffee Service Raising / Lowering the upper bas- ket Adjusting the Height of the Upper BasketAdding Detergent Concentrated detergents Detergent tabletsUsing 3in1 detergents If you want to use 3in1 productsIf you do not want to use 3in1 products any more If you want to use 4in1 productsSelecting the dishwashing cycle Cycle Table Suitable TypeSelecting a programme Interrupting or Cancelling a dishwashing cycle Setting the Delay TimerCancelling the wash programme Starting a Dishwashing CycleSwitching Off the dishwasher To change the time delayCancelling the delay timer Removing the DishesCare and cleaning Cleaning the filtersCleaning the spray arm jets Upper basket spray armBottom spray arm What to do if Remedying small malfunctionsIndicator for the end Dishwashing cycle is If the Dishwashing Results are not Satisfactory Dishes are still dirtyDishes do not dry and are not shining There are dried water drops on the glasses and dishesOld appliance DisposalPackaging material Technical Data Example loading arrangements Full load Half loadPage Installation and connection instructions Safety Information for the InstallationInstalling the Dishwasher Dishwashers That Can be IntegratedConnecting the dishwasher Connecting to the water supplyConnecting the inlet hose Permitted water pressureWater drainage Anti-flood systemGreen and Yellow Earth BlueNeutral BrownLive Electrical ConnectionChanging a fuse Connecting systems Warranty conditions Great Britain0870 5 929 Customer Care For general enquiries concerningAEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG