Electrolux ESF 45010 Cancelling the delay start, Cancel a washing programme in progress

Page 25

Cancelling the "delay start"

To cancel a delay start in progress you have to reset the dishwasher.

Press simultaneously and keep pressed the two programme buttons positioned over the writing Cancel, until all the programme button lights will illuminate.

Cancelling a delay start involves also the cancelling of the washing programme set. In this case you have to set the washing programme again.

Interrupt or cancel a washing programme in progress ONLY if it’s absolutely necessary.

Attention! Hot steam may escape when the door is opened. Open the door carefully.

Interrupt a washing programme in progress:

Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point at which it was interrupted.

daily use electrolux 25

Press the On/Off button, all indicator lights will turn off. Press the On/Off button again; the programme will start from the point at which it was interrupted.

Cancel a washing programme in progress

Press simultaneously and keep pressed the two programme buttons positioned over the writing Cancel, until all the programme button lights and in the digital display 3 horizontal lines appear. The washing programme has been cancelled.

If a new washing programme is to be selected, check that there is detergent in the detergent dispenser.

End of the washing programme

The dishwasher will automatically stop and the programme in progress indicator light turns off.

The end of programme indicator light will illuminate.

The indicator light of the programme just ended will remain on.

The digital display turns off.

1.Switch off the dishwasher by pressing the On/Off button.

2.Open the dishwasher’s door, leave it ajar and wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved.

Image 25 Contents
Dishwasher ESF We were thinking of you Welcome to the world of Electrolux Contents General safety Safety informationChild safety Correct useInstallation Product description Control panel Indicator lights Setting mode First use Water hardness Adjusting the water Hardness setting Mmol/lUse Salt Setting electronically Dishwasher is factory set at level Setting manually Dishwasher is factory set at positionExamples To fill Filling with dishwasher saltFilling with rinse aid Loading cutlery and dishes Daily useElectrolux daily use Lower basket Cutlery basket Upper basket Maximum height of the dishes Upper Basket Adjusting the height of the upper basketLower Basket To move to the higher position proceed as follows Fill with detergent Use of detergent Detergent tablets Activation/deactivation of the 3 in 1 function Activation/deactivation of the rinse aid dispenser Setting and starting the programme with delay start Programme in progress indicator light illuminatesCancel a washing programme in progress Cancelling the delay startEnd of programme indicator light will illuminate End of the washing programmeUnloading the dishwasher Programme Washing programmesDegree Soil Type of loadCleaning the filters Care and cleaningInternal cleaning External cleaningFrost precautions Never try to remove the spray armsPossible cause and solution Fault code and malfunctionSomething not working Malfunction Wash results are not satisfactory Dishes are not clean Dishes are wet and dullTechnical data Programme Duration Minutes Consumption values ProgrammeEnergy Consumption KWh Water Litres Hints for test institutes Full load 9 standard place settingsFitting under a counter kitchen worktop or sink InstallationProceed as follows LevellingLocknut must be correctly fitted to avoid water leaks Water supply connectionsWater inlet hose with safety valve Water outlet hose connection Electrolux installation Packaging material Environment concernsOld appliance European guarantee Albania Belgique/België/Belgien Electrolux Electrolux Electrolux Page 117997 87/1-01-26042007