Electrolux ESF 45010 user manual Electrolux installation

Page 40

40 electrolux installation

Electrical connection

Safety standards require the appliance to be earthed.

Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the supply where the appliance is to be installed. The fuse rating is also to be found on the rating plate.

Always plug the mains plug into a correctly installed shockproof socket.

Multi-way plugs, connectors and extension cables must not be used. This could constitute a fire hazard through overheating.

If necessary, have the domestic wiring system socket replaced. In case that the electrical cable has to be replaced, contact your local Service Force centre.

The plug must be accessible after the appliance has been installed.

Never unplug the appliance by pulling on the cable. Always pull the plug.

The manufacturer accepts no liability for failure to observe the above safety precautions.

Image 40

Contents Dishwasher ESF We were thinking of you Welcome to the world of Electrolux Contents Safety information General safetyChild safety Correct useInstallation Product description Control panel Indicator lights Setting mode First use Water hardness Adjusting the water Hardness setting Mmol/lUse Salt Setting electronically Dishwasher is factory set at level Setting manually Dishwasher is factory set at positionExamples Filling with dishwasher salt To fillFilling with rinse aid Daily use Loading cutlery and dishesElectrolux daily use Lower basket Cutlery basket Upper basket Adjusting the height of the upper basket Maximum height of the dishes Upper BasketLower Basket To move to the higher position proceed as followsFill with detergent Use of detergentDetergent tablets Activation/deactivation of the 3 in 1 function Activation/deactivation of the rinse aid dispenser Programme in progress indicator light illuminates Setting and starting the programme with delay startCancelling the delay start Cancel a washing programme in progressEnd of programme indicator light will illuminate End of the washing programmeUnloading the dishwasher Washing programmes ProgrammeDegree Soil Type of loadCare and cleaning Cleaning the filtersExternal cleaning Internal cleaningFrost precautions Never try to remove the spray armsPossible cause and solution Fault code and malfunctionSomething not working Malfunction Dishes are not clean Dishes are wet and dull Wash results are not satisfactoryTechnical data Programme Duration Minutes Consumption values ProgrammeEnergy Consumption KWh Water Litres Full load 9 standard place settings Hints for test institutesInstallation Fitting under a counter kitchen worktop or sinkProceed as follows LevellingWater supply connections Locknut must be correctly fitted to avoid water leaksWater inlet hose with safety valve Water outlet hose connection Electrolux installation Packaging material Environment concernsOld appliance European guarantee Albania Belgique/België/Belgien Electrolux Electrolux Electrolux Page 117997 87/1-01-26042007