Electrolux 64570 Vi manual What to do if, Remedying small malfunctions

Page 26

What to do if...

Remedying small malfunctions

If the acoustic signal is activated, warning tones sound if there are faults.

If one of the following fault codes is displayed in the multi-display dur- ing operation:

Fault codeÅ 10 (Problems with water inlet),

Fault codeÅ 20 (Problems with water drainage), please have a look at the following table.

When the fault is remedied, press the button for the cycle that has started. The cycle will continue.

With other fault codes (“Å ” followed by a number):

Abort the dishwashing cycle.

Switch the appliance off and on again.

Re-set the dishwashing cycle.

If the fault is displayed again, please contact your local Service Force Centre and inform them of the fault code.

Malfunction

Possible cause

Remedy

 

Water tap is blocked with

Check the water tap and

 

limescale or faulty.

have it repaired if necessary.

 

The tap is turned off.

Turn the tap on.

1 short warning tone

The filter (where present) in

Clean the filter in the

continuously repeated can

the threaded hose fitting

threaded hose fitting.

be heard,

on the tap is blocked.

 

the cycle indicator for the

 

 

 

Press the button for the

selected dishwashing cycle

 

 

commenced dishwashing

is flashing:

 

 

cycle;

fault code Å 10 is dis-

Filters in the base of the

then abort the dishwashing

played in the multi-dis-

dishwasher compartment

cycle (see section: Starting a

play:

are blocked.

dishwashing cycle);

(Problems with water in-

 

 

clean filters (see section:

let)

 

 

Cleaning the filters).

 

 

 

Water inlet hose

Check the position of the

 

has not been correctly posi-

 

hose.

 

tioned.

 

26

Image 26
Contents Favorit 64570 Following symbols are used in the text Dear CustomerContents Child Safety SafetyPrior to using for the first time Follow the Instructions for installation and connectionGeneral Safety Risk of frostDiagram of Appliance Control PanelFunction button Sets the water softener Prior to Using for the First Time Setting the Water Softener10L Only when using the dishwasher for the first time Adding dishwasher saltFilling Up with Rinse Aid Setting the Amount of Rinse Aid Required Activating/Deactivating the Rinse Aid dispenserActivating/deactivating the acoustic signal Daily use Loading cutlery and dishesLoading cutlery Pots, Pans, Large Plates Load large and heavily soiled dishes in the lower basketGlass holders Cups, Glasses, Coffee ServiceAdjustable cup racks Adjusting the height of the upper basket Raising/Lowering the Upper Bas- ketAdding Detergent Detergent tablets Using 3in1 detergentsConcentrated detergents Selecting the dishwashing cycle Cycle Table Suitable TypeCancelling the time delay Setting the Delay TimerTo change the delay timer Starting a dishwashing cycleRemoving the Dishes Care and cleaningSwitching off the dishwasher Polished chromium steel surfacesFine filter Cleaning the filtersCoarse filter Middle spray arm Cleaning the spray armsTop spray arm Lower spray armWhat to do if Remedying small malfunctionsMalfunction Possible cause Remedy Short warning tones Dishes do not dry and are not shining If the Dishwashing Results are not SatisfactoryDishes are still dirty There are dried water drops on the glasses and dishesPackaging material Technical dataDisposal Old applianceMeasurement of noise Sample loading arrangementsTeaspoon Scope of use GeneralWater Supply Connection Water Outlet Hose ConnectionInstalling and fitting the hinged door Hinged door must be fitted with a handleFitting the hinged door Page Page Page Green and Yellow Earth Blue Neutral Brown Live Electrical ConnectionChanging a fuse Permanent Connection Warranty conditions Great BritainPage Service and Spare Parts 0870 5 929AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG