Electrolux 64570 Vi manual Electrical Connection, Changing a fuse

Page 39

Electrical Connection

1 WARNING - This appliance must be earthed.

The manufacturer declines any responsibility should these safety measures not be observed.

Before switching on make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.

To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.

Changing a fuse

The appliance is supplied with a 13amp plug fitted. In the event of hav- ing to change the fuse in the plug supplied, a 13amp ASTA approved (BS 1363A) fuse must be used.

Should the plug need to be replaced		Green & Yellow
for any reason, proceed as described
below.
The wires on the mains lead are col-
oured in accordance with the fol-
lowing code.	Blue
	Blue	Brown
Green and Yellow: Earth
Blue:	Neutral
Brown:	Live

Cord Clamp

•The wire coloured green and yellow must be connected to the termi-

nal marked with the letter “E“ or by the earth symbol or coloured green and yellow.

•The wire coloured blue must be connected to the terminal “N“ or col- oured black.

•The wire coloured brown must be connected to the terminal marked “L“ or coloured red.

•Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

1WARNING! A cut off plug inserted into a 13 amp socket is a seri- ous safety (shock) hazard. Ensure that the cut of plug is disposed of safely.

39

Image 39

Contents Favorit 64570 Dear Customer Following symbols are used in the textContents Follow the Instructions for installation and connection SafetyPrior to using for the first time Child SafetyRisk of frost General SafetyControl Panel Diagram of ApplianceFunction button Sets the water softener Setting the Water Softener Prior to Using for the First Time10L Adding dishwasher salt Only when using the dishwasher for the first timeFilling Up with Rinse Aid Activating/Deactivating the Rinse Aid dispenser Setting the Amount of Rinse Aid RequiredActivating/deactivating the acoustic signal Loading cutlery and dishes Daily useLoading cutlery Load large and heavily soiled dishes in the lower basket Pots, Pans, Large PlatesCups, Glasses, Coffee Service Adjustable cup racksGlass holders Raising/Lowering the Upper Bas- ket Adjusting the height of the upper basketAdding Detergent Using 3in1 detergents Concentrated detergentsDetergent tablets Suitable Type Selecting the dishwashing cycle Cycle TableStarting a dishwashing cycle Setting the Delay TimerTo change the delay timer Cancelling the time delayPolished chromium steel surfaces Care and cleaningSwitching off the dishwasher Removing the DishesCleaning the filters Coarse filterFine filter Lower spray arm Cleaning the spray armsTop spray arm Middle spray armRemedying small malfunctions What to do ifMalfunction Possible cause Remedy Short warning tones There are dried water drops on the glasses and dishes If the Dishwashing Results are not SatisfactoryDishes are still dirty Dishes do not dry and are not shiningOld appliance Technical dataDisposal Packaging materialSample loading arrangements Measurement of noiseTeaspoon General Scope of useWater Outlet Hose Connection Water Supply ConnectionHinged door must be fitted with a handle Installing and fitting the hinged doorFitting the hinged door Page Page Page Electrical Connection Changing a fuseGreen and Yellow Earth Blue Neutral Brown Live Permanent Connection Great Britain Warranty conditionsPage 0870 5 929 Service and Spare PartsAEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG