Prior to Using for the First Time
1.Set the water softener
2.Fill up with dishwasher salt
3.Fill up with rinse aid
3 If you wish to use 3in1 detergent, do the following:
–First read the section “Using 3in1 detergents”.
–Switch on the dishwasher, press the 3in1 button. The button indicator lights up: 3in1 function is selected. As a result
–there is no need to fill up with dishwasher salt or rinse aid.
–there is no need to set the water softener.
–there is no need to set the rinse aid dispenser.
–Before the start of the dishwashing cycle put 3in1 detergent in the detergent dispenser.
3 Once this additional function has been selected, it remains activated for all further dishwashing cycles until it is cancelled by pressing the button again.
3
3 When changing from 3in1 detergent tablets to normal detergent, it is most important to observe the last 3 points in the section “Using 3in1 detergents”.
Setting the Water Softener
3 To avoid scale deposits on the dishes and in the dishwasher, the dishes must be washed with soft water, i.e. water with a low lime content. The water softener must be set according to the table to the water hard- ness in the area where you live. Your local water company will be able to give you information about the water hardness in your area.
1.Press the ON/OFF button.
3 If the LED indicator of only one programme button is illuminated, this wash programme has been activated. The wash programme must be deselected:
Press function buttons 2 and 3 simultaneously for approx. 2 seconds. The LED indicators of all the buttons that can be selected will illumi- nate.
Exception: The 3in1 button will only illuminate if the function has been activated.
8