Operating instructions
Something not working
Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions given here, without calling out an engineer.
Important: If you call out an engineer to a fault listed below or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is in guarantee.
...a flashing fault code appears
The dishwasher will not start or stops during operation and a sequence of intermittent audible signals are heard.
The
Open the dishwasher’s door.
The intervention of an alarm is indicated by:
-the continuous flashing of the indicator light of the running programme,
-in the digital display is visible a fault code (as described in the chart). Carry out the following suggested corrective actions.
Fault code / Malfunction
in the digital display appears 
The machine does not fill with water
in the digital display appears 
The dishwasher will not drain
Possible cause
The water tap is blocked or furred with limescale.
The water tap is turned off.
The filter (where present) in the threaded hose fitting at the water inlet valve is blocked.
The water inlet hose has not been correctly laid or it is bent or squashed.
The sink spigot is blocked.
The water drain hose has not been correctly laid or it is bent or squashed.
Solutions
Clean the water tap.
Turn the water tap on.
Clean the filter in the threaded hose fitting.
Check the water inlet hose connection.
Clean out the sink spigot.
Check the water drain hose connection.
in the digital display | |
appears | contact your local Service |
| Force Centre. |
36