Electrolux 65080 VIL manual Water outlet hose connection

Page 47

Installation instructions

Water outlet hose connection

The end of the drain hose can be connected in the following ways:

1.To the sink outlet spigot, securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine.

2.Hooked over the edge of the sink using the special curved plastic guide (if provided with the machine).

3.To a stand pipe provided with vent-hole, minimum internal diameter 4 cm.

The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher.

The drain hose can face either to the right or left of the dishwasher

Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water.

The sink plug must not be in place when the machine is draining as this could cause the water to syphon back into the machine.

If you use a drain hose extension it must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided.

Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided.

Attention!

Our appliances are supplied with a security device to protect against the return of dirty water back into the machine.

If the spigot of your sink has a "no return valve" incorporated this can prevent the correct draining of your dishwasher.

We advise you therefore to remove it.

47

Image 47

Contents Favorit 65080 VIL Dear customer Following symbols are used in the textContents Child safety Safety instructionsInstallation Your dishwasher in day-to-day use Economical and ecological dishwashing DisposalDescription of the appliance Digital display indicates Control panel1 function Activation/deactivation of the 3 in 1 function 1 function active Indicator light onIndicator light off Activation/deactivation of the rinse aid dispenser Factory setting audible signals activated Audible signalsDeactivation/activation of the audible signals Water softener Prior to using for the first timeSetting electronically Setting manuallyExamples ExampleTo fill Filling with dishwasher saltEnsure that the lid is closed after every refill Rinse aidFilling with rinse aid Adjusting the dose Loading cutlery and dishes Daily useGlazed patterns may fade if machine washed frequently Lower basket Cutlery basket Upper basket Case that plates are loaded in the upper basket To move to the higher position proceed as follows Adjusting the height of the upper basketFill with detergent Use of detergentCombi detergents Different kinds of detergentDetergent tablets Concentrated detergentUse of 3 in 1 combi detergents General adviceSpecial advice Programme Washing programmesStarting a washing programme Setting and starting the programmeSetting and starting the programme with the delay start Cancel a washing programme in progress To interrupt or cancel a washing programme in progressTo cancel a delay start in progress Unloading the dishwasher End of the washing programmeCleaning the filters Maintenance and cleaningNever try to remove the upper spray arm Moving the machine Frost precautionsProlonged periods of non-operation Something not working Flashing fault code appearsThere are problems when operating the dishwasher Water drops have dried onto glasses and dishes Dishes are not cleanWash results are not satisfactory Dishes are wet and dullService 08705 Service and Spare PartsCustomer Care Department Exclusions Guarantee ConditionsStandard Guarantee Conditions This guarantee does not coverEuropean Guarantee Electrical connection Technical specificationsFixing to the adjacent units Building-inLevelling Water supply connections Please take care when installing the water inlet hose Water inlet hose with safety valveWater outlet hose connection Proceed as follows Electrical connectionGreen and Yellow Earth Blue Brown LiveInstallation instructions Hints for test centres Page Postfach 90327 Nürnberg Copyright by AEG