Installation - Fig. 8
•Drill the base of the wall unit to allow for passage of the hood body. Fig. 7.
•Drill the top of the wall unit to allow for passage of the exhaust pipe and the electrical cable. Fig. 7.
•Remove the grease filter (1).
•Remove the grease filter support frame, by pressing the two spring clamps located at the sides of the frame (2).
•Through the top of the wall unit, insert a pipe with a diameter of 120mm at the connection ring (3).
•Fit the connection ring on the hood exhaust outlet (4) and fasten it to the exhaust pipe.
•Insert the body of the hood into the hole in the base of the wall unit
(5)– check the position of the exhaust pipe and the electrical cable, press firmly so that the anchor springs (6) engage above the bottom of wall unit. Tighten the screws in the anchor springs firmly.
•If necessary the hood can be fastened with four more screws (7).
•Replace the grease filter support frame.
•Replace the grease filter.
15