English

ASSEMBLY AND OPERATION

APPLICATIONS

Cutting Various types of wood.

REMOVAL AND INSTALLATION METHOD OF BATTERY

Insert

Pull out

Latch

Battery Push

Fig. 10

How to install the battery.

Align both guide rails of the battery and the tool.

Always insert the battery all the way until it locks in place with a little click, If not, it may accidentally fall out of the tool, causing injury to you or someone around you. (Fig. 4)

How to remove the battery.

Withdraw the battery from the tool while pressing the latches on both sides of the battery. (Fig. 4)

CHARGING METHOD

NOTE: Before plugging into the receptacle, make sure the following points.

The power source voltage is stated on the nameplate.

The cord is not damaged.

WARNING: Do not charge at voltage higher than indicated on the nameplate.

If charged at voltage higher than indicated on the nameplate, the charger will burn out.

1.Insert the plug of battery charger into the receptacle.

When the plug of battery charger has been inserted into the receptacle, pilot lamp will blink in red. (At 1-second intervals)

WARNING:

Do not use the electrical cord if damaged. Have it repaired immediately.

17

Page 17
Image 17
Hitachi C 7D Assembly and Operation, Applications, Removal and Installation Method of Battery, Charging Method