English

MOUNTING AND DISMOUNTING THE SAW BLADE

CAUTION:

To avoid serious accident, ensure the switch is in the OFF position, and pull out the battery.

1. Dismounting the saw blade

(1)Set the cutting volume at maximum, and place the Circular Saw as shown in Fig. 19.

(2)Depress the lock lever, lock the spindle, and remove the hexagonal-flange bolt and washer(B) with the box wrench.

(3)While holding the safety cover lever to keep the safety cover fully retracted into the saw cover, remove the saw blade. (Fig. 20)

2. Mounting the Saw Blade (Fig. 21)

WARNING:

If the bolt is worked using other tools than the provided box wrench, excessive tightening and insufficient tightening may take place, resulting in injury.

Take procedures here that are contrary to the detaching procedures.

NOTE:

Thoroughly remove any sawdust which has accumulated on the spindle, bolt and washers.

To assure proper rotation direction of the saw blade, the arrow direction on the saw blade must coincide with the arrow direction on the saw cover.

Using the fingers, tighten the hexagonal flange bolt retaining the saw blade as much as possible. Then depress the lock lever, lock the spindle, and thoroughly tighten the hexagonal flange bolt.

CAUTION:

After mounting the saw blade, reconfirm that the lock lever is firmly secured in the prescribed position.

Box Wrench

Tighten Loosen

 

Lock Lever

 

Fig. 19

Saw

Safety Cover

Blade

 

 

Saw Cover

Safety Cover

Lever

Fig. 20

Saw Blade

Washer (B)

HexagonalWasher (A)

Flange Bolt

Fig. 21

25

Page 25
Image 25
Hitachi C 7D Mounting and Dismounting the SAW Blade, Dismounting the saw blade, Mounting the Saw Blade Fig