English
CAUTION:
●Don’t remove circular saw from workpiece during a cut while the saw blade is moving.
●Pull out the battery after completing operation.
NOTE:
Take care not to lock the motor. If the motor is locked, immediately turn the power off. If the motor is locked for a while, the motor or battery may be burnt.
1. Operation of switch (switch trigger and light switch) |
| ||
(1) For safe operation of the machine, a |
| Switch Lock | |
“switch lock” is provided on the side of a |
| ||
| (Be used as both | ||
handle. |
| ||
Switch Trigger | Switch Lock and | ||
If the “switch lock” is pulled in a state | |||
Light Switch) | |||
where it is pressed in the direction of the |
| ||
|
| ||
arrow mark, the main switch can be turned ON.
And the “switch lock” is used as the “light switch”. If the “switch lock (light switch)” is pulled in a state, the light is turned ON.
(2) After the switch is turned ON, even when you release your hand from the switch lock, the saw blade continues running and the light continues being turned ON as long as you keep on pulling the switch trigger.
(3)If you release the switch trigger, you can turn OFF the switch and the “switch lock” returns to the original position automatically and the light turns OFF too.
NOTE:
If the saw is set aside with the battery still installed, then depending on the orientation of the saw, if the “Switch Lock” comes in contact with the floor surface or wall surface, the light can remain on continuously. Please be aware that if the light is allowed to remain on continuously, even a fully charged battery can be completely discharged in about 3 hours.
2. Working performance per single charge (Reference data)
Cutting capability differs according to the condition of lumber, type of saw blade, ambient temperature, battery characteristics, etc.
Wood | Capacity |
|
|
2 ⋅ 8 | 85 (cuts) |
|
|
Concreteform plywood (1/2” (12 mm) t) | 148 ft (45 m) |
|
|
To improve working efficiency per single charge,
Minimize operation
23
