Electrolux ZKS5653 user manual Electrical connection, Fitting under a counter, Levelling

Page 23

Electrical connection

CAUTION!

Safety standards require the appliance to be earthed.

Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the supply where the appliance is to be installed.

The fuse rating is also to be found on the rating plate.

Always plug the mains plug into a correctly in- stalled shockproof socket. Multi-way plugs, connectors and extension cables must not be used.

This could constitute a fire hazard through over- heating.

If necessary, have the domestic wiring system socket replaced. In case that the electrical ca- ble has to be replaced, contact your local Serv- ice Force centre.

The plug must be accessible after the appliance has been installed.

Never unplug the appliance by pulling on the cable. Always pull the plug.

The manufacturer accepts no liability for failure to observe the above safety precautions.

Fitting under a counter

IMPORTANT!

Carefully follow the instructions on the enclosed template for building in the dishwasher and fit- ting the furniture panel.

WARNING!

The dishwasher must be secured against tilting. Therefore make sure that the counter it is fixed under, is suitably secured to a fixed structure (adjacent kitchen units cabinets, wall).

This dishwasher is designed to be fitted under a kitchen counter or work surface.

No further openings for the venting of the dishwasher are required, but only to let the wa- ter fill and drain hose and power supply cable pass through.

The dishwasher incorporates adjustable feet to allow the adjustment of the height.

During all operations that involve accessibility to internal components the dishwasher has to be unplugged.

Be sure that once the appliance has been in- stalled, it is easily accessible for the service engineer in the event that a repair is required.

Levelling

Good levelling is essential for correct closure and sealing of the door.

When the appliance is correctly levelled, the door will not catch on either side of the cabinet. If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level. (See enclosed template).

23

Image 23
Contents Dishwasher ZKS5653 Contents Correct use Safety informationGeneral safety Child safetyControl panel InstallationStarting the washing programme Cancel the washing programme in progressIndicator lights End of programme indicator lightType of load Salt refilling indicator lightWashing programmes Degree of soilSet the water softener When using tablets that integrate rinse aid and detergentFirst use Use of salt Setting the water softener manually see tableWater hardness Mmol/l Salt for the first time, fill Setting the water softener electronically see tableFilling with dishwasher salt Only before filling withFilling with rinse aid Loading cutlery and dishes Adjusting the dosage of rinse aidAre of limited suitability Lower basket Adjusting the height of the upper basketMaximum height of the dishes Upper basketUnloading the dishwasher Use of detergentExternal cleaning Care and cleaningCleaning the filters Cleaning the spray armsEnvironmental concerns Something not working Fault code and malfunctionPossible cause and solution Programme does not start Wash results are not satisfactory Technical dataHints for test institutes Full load 12 standard place settingsConsumption values Cup racks position a InstallationWater inlet hose with safety valve Water connectionMust be removed . Fail Drain hosePlastic membrane a Levelling Electrical connectionFitting under a counter 156994870-00-20072007 Subject to change without notice