Electrolux 40300 manual There are problems with the operation of the dish- washer

Operating Instructions

...there are problems with the operation of the dish- washer.

Symptom	Possible Cause	Solution
The drain pump in the
dishwasher runs con-	The anti-flood system has	Close the tap, then unplug
tinuously - even with		from the mains and contact
	been triggered.
the appliance switched		AEG Service Force.
off.
	The door of the dishwasher is	Shut the door.
	not closed properly.
The programme does	Mains plug is not plugged in.	Insert mains plug.
	House fuse in defective.	Replace fuse.
not start.
		If the dishes are to be
	A delay start is selected.	washed immediately, set the
		delay start to 0 hours
	The washing compartment is	Only wash cutlery and dishes
	made of corrosion-resistant	that are suitable for dish-
	stainless steel. Rust spots in	washer use.
	the washing compartment
Rust spots are visible in	are from particles from out-
the washing compart-	side the appliance (rust par-
ment.	ticles from the water pipe,	Close the lid of the special
	from pans, cutlery, etc.).
		salt container securely.
	Remove such spots with a
	commercially available stain-
	less steel cleaner.
There is a whistling	The whistling is not a cause	Use a different brand of
noise during washing.	for concern.	detergent.

...the wash result is unsatisfactory.

The dishes are still dirty.

–The wrong wash programme was selected.

–The dishes were arranged in such a manner that water has not reached all parts. The dish racks must not be overloaded.

–The filter in the base of the washing compartment is dirty or incor- rectly positioned.

–Detergent was not used or too little was used.

25