Electrolux 40300 manual Unscrew the screws 1 from the elbows on the back side

Page 30

Installation and Connection Instructions

•If the dishwasher is installed under- neath a kitchen work surface, the original work surface of the dish- washer is to be removed as follows:

–Unscrew the screws (1) from the elbows on the back side.

–Slide the work surface approx. 1cm to the rear (3) , lift at the front (4) and remove.

–Press the work surface retaining brackets at the position shown in the diagram (4) and remove the bracket at an angle to the rear

(5).

4

5

•The dishwasher must also be screwed on tightly to the work surface or to the adjoining units. This is absolutely necessary so that its sta- bility is guaranteed according to VDE regulations.

1If the dishwasher is later used as a free-standing appliance, the original work surface must be re-mounted.

3 The plinth on free-standing appliances is not adjustable.

30

Image 30

Contents Ökofavorit Please read these user instructions carefully Tips on using the applianceDear customer Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions Child Safety Safety InstructionsInstallation, Connection and Placing into Operation General SafetyCorrect Use Disposing of the Packaging Material DisposalEconomical and Ecological Dishwashing Disposal of Old AppliancesAppliance Features and Control Panel Prior to using for the first time Control PanelAdjust the Water Softener Your areaOpen the door, remove the lower Rack Filling with Salt for the Water SoftenerFill with dishwasher salt Turning it anticlockwiseAge the appliance Filling with Rinse AidOugh rinsing, spot and streak free drying Fill with rinse aidAdjusting Rinse Aid Dosing Daily Use Loading Cutlery and DishesLoading Cutlery Loading Pans, Frying Pans and Large Plates Load large and heavily soiled dishes in the lower rackLoading Cups, Glasses Coffee Services Filling with Detergent Fill with detergentBio Wash Programmes and Concentrated Detergents Detergent RecommendationsSelecting the Wash Programme Programme Table Type of SoilingStarting the Wash Programme Changing/Interrupting the Wash ProgrammeChanging the wash programme Switching Off the Dishwasher Emptying the DishwasherWasher Care and Cleaning Cleaning the FilterWhat to do, if Put the flat filter back in the base Washing compartmentStances Dishes are still dirty There are problems with the operation of the dish- washerWash result is unsatisfactory Wrong wash programme was selectedRinse aid was not used Rinse aid container is empty Drain hose is incorrectly laidDishes are wet and dull Decrease rinse aid dosingTechnical Data Sample loading arrangements Upper basket Lower basket with cutlery basketInstalling the Dishwasher Free-Standing AppliancesCannot be kinked or crushed Unscrew the screws 1 from the elbows on the back side Permitted water pressure Connecting the DishwasherWater Connection Connect the inlet hoseExtension hoses Water drainDrain hose Sink outlet connectionLeak Prevention System Appliance is automatically pumped outElectrical Connection Changing a fuseConnections Guarantee Conditions Page Page 08705 929 Customer CareCalls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG