Electrolux 40300 Installing the Dishwasher, Free-Standing Appliances, Cannot be kinked or crushed

Page 29

Installation and Connection Instructions

INSTALLATION AND CONNECTION INSTRUCTIONS

Installing the Dishwasher

•The dishwasher must be installed on a firm floor and adjusted such that it is stable and level.

• To compensate for unevenness in the floor and to match the height of the appliance to that of surrounding units extend the threaded feet by unscrew- ing:

– use a screwdriver.

	• The drain hose, inlet hose and mains cable must be laid such that
	they are free to move in the rear of the plinth recess, so that they
	cannot be kinked or crushed.
	Free-Standing Appliances
1	• can be set up as stand-alone without additional installation.
	If the dishwasher is set up next to a gas or coal cooker, a heat-

insulating, non-flammable plate must be mounted between the dishwasher and the cooker, flush to the top edge of the work surface (depth 57.5 cm). The plate should have aluminium foil on the side facing the cooker.

29

Image 29

Contents Ökofavorit Dear customer Tips on using the appliancePlease read these user instructions carefully Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions Installation, Connection and Placing into Operation Safety InstructionsChild Safety General SafetyCorrect Use Economical and Ecological Dishwashing DisposalDisposing of the Packaging Material Disposal of Old AppliancesAppliance Features and Control Panel Control Panel Prior to using for the first timeYour area Adjust the Water SoftenerFill with dishwasher salt Filling with Salt for the Water SoftenerOpen the door, remove the lower Rack Turning it anticlockwiseOugh rinsing, spot and streak free drying Filling with Rinse AidAge the appliance Fill with rinse aidAdjusting Rinse Aid Dosing Loading Cutlery and Dishes Daily UseLoading Cutlery Load large and heavily soiled dishes in the lower rack Loading Pans, Frying Pans and Large PlatesLoading Cups, Glasses Coffee Services Fill with detergent Filling with DetergentDetergent Recommendations Bio Wash Programmes and Concentrated DetergentsType of Soiling Selecting the Wash Programme Programme TableChanging the wash programme Starting the Wash ProgrammeChanging/Interrupting the Wash Programme Washer Switching Off the DishwasherEmptying the Dishwasher Cleaning the Filter Care and CleaningStances What to do, ifPut the flat filter back in the base Washing compartment Wash result is unsatisfactory There are problems with the operation of the dish- washerDishes are still dirty Wrong wash programme was selectedDishes are wet and dull Drain hose is incorrectly laidRinse aid was not used Rinse aid container is empty Decrease rinse aid dosingTechnical Data Upper basket Lower basket with cutlery basket Sample loading arrangementsCannot be kinked or crushed Installing the DishwasherFree-Standing Appliances Unscrew the screws 1 from the elbows on the back side Water Connection Connecting the DishwasherPermitted water pressure Connect the inlet hoseDrain hose Water drainExtension hoses Sink outlet connectionAppliance is automatically pumped out Leak Prevention SystemChanging a fuse Electrical ConnectionConnections Guarantee Conditions Page Page Calls may be recorded for training purposes 08705 929Customer Care AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG