Fitting the Stability Bracket
(Not supplied)
If the cooker has to be installed with a flexible supply pipe, it is necessary that a stability device is fitted.
(See "Important Safety Requirements").
The stability bracket should be fitted by the installer and these instructions should be read in conjunction with the leaflet packed with the stability bracket.
Place cooker in its intended position and level cooker.
Mark off 295mm (11 1/2") from the right hand side of the cooker as shown, this is the centre line of the bracket fixing.
Draw a line 100mm (4") from the front edge of the levelling feet and remove cooker from its position. Mark off 580mm (23") back from this line on the centre line of the bracket to locate the front edge of the lower bracket.
electrolux 29
Fix lower bracket (with two fixing holes) to the floor, then measure height from floor level to engagement edge on back of cooker, dimension 'A' of figure.
Assemble upper bracket to lower bracket so that underside of bracket is dimension 'A' +3mm (1/8") above floor level. Re- position cooker and check that top bracket engages into cooker back to a depth of 75mm (3"), as shown in figure.
Should the stability bracket currently installed not allow the cooker to stand correctly, ask the installer to replace it with the correct type.
|
| 300 mm. |
|
|
WALL FACE |
|
|
| |
|
|
|
| BACK OF COOKER |
580 mm. | mm. |
|
| ENGAGEMENT EDGE FOR |
LEVELLING FEET |
| STABILITY BRACKET | ||
| 100 |
| ||
|
|
|
| |
|
|
| A | BASE OF COOKER |
|
|
|
| |
| PENCIL LINE ON THE FLOOR |
|
|
|
|
| 295 mm. |
|
|
| PLAN VIEW OF THE COOKER |
| SIDE VIEW | |
|
| OF THE COOKER | ||