Electrolux EKM 70150 manual Electrical connection, Permanent Connection

Page 32

32electrolux

Electrical connection

Any electrical work required to install this cooker should be carried out by a qualified electrician or competent person, in accordance with the current regulations.

THIS COOKER MUST BE EARTHED.

The manufacturer declines any liability should these safety measures not be observed.

This cooker is designed to be connected to a 230 V 50 Hz AC electrical supply.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the cooker rating plate. The rating plate is located on the oven frame.

The cooker is supplied with a 3 core flexible supply cord incorporating a 13amp plug fitted. In the event of having to change the fuse, a 13amp ASTA approved (BS 1362) fuse must be used.

Should the plug need to be replaced for any reason, the wires in the mains lead are coloured in accordance with the following code:

—Connect the brown (live) wire to the terminal in the plug which is marked with the letter 'L' or coloured red.

Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut off plug is disposed of safely.

Permanent Connection

In the case of a permanent connection, it is necessary that you install a double pole switch between the cooker and the electricity supply (mains), with a minimum gap of 3 mm. between the switch contacts and of a type suitable for the required load in compliance with the current electric regulations.

The switch must not break the yellow and green earth cable at any point.

Ensure that the cooker supply cord does not come into contact with surfaces with temperatures higher than 50 deg. C.

Green and Yellow

- Earth

Blue

- Neutral

Brown

- Live

—Connect the green and yellow (earth) wire to the terminal in the

plug which is marked with the letter 'E' or the earth symbol or coloured green and yellow.

—Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter 'N' or coloured black.

1

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Instruction booklet Page Welcome to the world of Electrolux Contents During use Important safety informationPeople safety Page Service Environmental InformationGas cooktop Control knobs on the gas hobPots must not enter the con- trol zone Burner Minimum MaximumSafety Thermostat Electric ovenOven function and thermostat control knobs Oven Thermostat Pilot LightBefore the first use of the appliance To open the oven door, always hold the handle in the centreHints and tips for using the hob PotteryHints and tips for using the oven Condensation and SteamCookware Always cook with the oven door closedChoosing a suitable cookware utensil Oven accessoriesOven cavity Hints and Tips on Cooking Fish and Meat Hints and Tips on bakingHints and Tips on grilling Cooking timesFan cooking Conventional cookingGrilling Cooking chart- Conventional and fan cooking Type of DishCooking Chart Grilling Type of DishMaintenance and cleaning Hob topPan supports BurnersExternal cleaning Cleaning the ovenCleaning materials Oven door and its gasket ModelsinstainlesssteeloraluminiumOven lamp replacement Disconnect the appliance from the electricity supplySymptom Solution Something not workingTechnical data DimensionsGas Hob Electric OvenBurner characteristics By-pass diametersImportant Safety Requirements Provision for VentilationLevelling Positioning the CookerMounting the splashback Fig. aFitting the Stability Bracket Not supplied Wall FaceGas connection Commissioning Electrical connection Permanent ConnectionFitting between cabinets Service and spare parts European guaranteeGuarantee/Customer Service Service and Spare PartsCustomer Care Electrolux Page Page 35905-9402 09/08 R.A
Top Page Image Contents