The rounded ends of the shelf support rails must point to the front!
Oven lamp
Warning! There is a danger of electrical shock!
Before you change the oven lamp:
•Switch off the oven.
•Remove the fuses in the fuse box or switch off the circuit breaker.
Put a cloth on the bottom of the oven for protection of the oven light and glass cover.
Replacing the oven lamp
1.You can find the lamp glass cover at the back of the cavity.
Turn the lamp glass cover counterclock- wise to remove it.
2.Clean the glass cover.
3.Replace the oven lamp with applicable 300°C
Important! Use the same oven lamp type. 4. Install the glass cover.
Oven Ceiling
You can fold down the heating element on the oven ceiling to clean the oven ceiling easily.
Warning! Before you fold down the heating element switch off the appliance. Make sure that the appliance is cold.
There is a risk of burns!
Folding down the heating element
1.Remove the shelf support rails.
2.Hold the heating element with the two hands at the front
3.Pull it forwards against the spring pres- sure and out along the support on both sides.
4.The heating element folds down. The oven ceiling is ready to clean.
electrolux 17
Installing the heating element
1.Install the heating element in opposite se- quence.
Important! Install the heating element correctly on the two sides above the support on the inner wall of the oven. 2. Insert shelf support rails.
Oven door and glass panels
To clean the oven door remove it.
Caution! Be careful when you remove the door from the appliance. The door is heavy!
Removing the oven door
1.Open the oven door as far as it goes.
2.Lift up clamping levers (A) on the two door hinges fully.
A
A
3. Close the oven door until the first posi- tion (angle approx. 45°).