Bose AM262838_00_V manual Setting up the remote control, Setting up a Zone 2 remote control

Setting Up

Connecting the Acoustimass® module to the Lifestyle® media center

Figure 13

Connecting the speakers to your Lifestyle® media center

AUDIO

INPUT

RIGHT

R	AM		FM	75
		ANTENN		A	R
			OPTICAL		R
	OPTICAL
R
	1
					DIGITAL

OUTPUTS

TO

CUBE

SPEAKERS

OFF

POWER

ON

LEFT

L	OUTPUT	PUTS
INPUT	AUDIO OUT

2		R
SPEAKE
	ZONES

FIX

Figure 14

Setting up a Zone 2 remote control

Note: To extend the length of the cables, use the supplied 50-foot extension cable (shown in the dotted line above). This cable connects between the 30-foot audio input cable and the 3- foot FIX adapter cable.

To connect the Acoustimass 5 or 20 powered speakers to your system (Figure 13), follow these steps:

1.Using the supplied 30-foot audio input cable, insert the DIN connector into the Acoustimass module, and the RCA plugs into the supplied 3-foot adapter cable labeled FIX on the single-connector end.

2.Attach the end of the 3-foot FIX adapter cable to the ZONE 2 output jack on the rear of the Lifestyle® media center.

Setting up the remote control

You need to set up a second remote control to operate the ZONE 2 output.

1.Remove the remote control battery cover and locate the miniature switches (Figure 14).

2.Make sure that the house code settings (switches 1, 2, 3, and 4) match those on your first remote.

3.Make sure switches 5, 7, and 8 are up, and 6 and 9 are down.

Note: Refer to your Lifestyle® system owner’s guide for more information on operating your system in more than one room.

ON

12 December 20, 2001 AM262838_00_V.pdf