Viking F20875 EN manual Water and Ice Dispensers, Calibrate Measured Fill

Operation

Ice Maker and Ice Storage Bin (cont.)

Remember

•The quality of your ice will be only as good as the quality of the water supplied to the ice maker. AVOID connecting the ice maker toa softened water supply. Water softener chemicals (such as salt) can damage parts of the ice maker and lead to poor quality ice. If a softened water supply cannot be avoided, make sure the water softener is operating properly and is well maintained.

•DO NOT use anything sharp to break up the ice in the bin. This can cause damage to the ice bin and dispenser mechanism.

•DO NOT store anythingon top of the ice maker or in the ice storage bin.

Water and Ice Dispensers

IMPORTANT:

•After connecting the refrigerator to a water source or replacing the water filter, flush the water system. Use a sturdy container to depress and hold the water dispenser lever for 5 seconds, then release it for 5 seconds. Repeat until water begins to flow. Once water begins to flow, continue depressing and releasing the dispenser paddle (5 seconds on, 5 seconds off) until a total of 4 gal. (15 L) has been dispensed. This will flush air from the filter and water dispensing system, and prepare the water filter for use. Additional flushing may be required in some households. As air is cleared from the system, water may spurt out of the dispenser.

•Allow 24 hours for the refrigerator to cool down and chill water.

•The dispensing system will not operate when refrigerator door is open.

Calibrate Measured Fill

Low water pressure may affect the accuracy of the Measured Fill feature. So, for optimum performance of your water dispenser, you must first calibrate Measured Fill.

Water and Ice Dispensers (cont.)

2. Press and hold the OPTIONS and LOCK buttons at the same time for 3 seconds. The words “Back” and “1 Cup” will appear on the display screen. Also, the Calibrate Measured Fill icon will illuminate and remain lit while the Measured Fill feature is being calibrated

NOTE: You may press the ICE MODE button under the word “Back” at any time to exit calibration mode. The Calibrate Measured Fill icon will turn off.

3.	Press and release the water dispenser paddle, as
	needed, to dispense water to the 1 cup fill line.
	NOTE: If overfilling or spilling occurs, discard
	the water and press “Back” to restart the
	calibration process.
4.	When 1 cup of water has been correctly
	dispensed into the measuring cup, press the
	MEASURED FILL button under the word

Operation

IMPORTANT: Flush the water system before calibrating Measured Fill.

1.Place a sturdy measuring cup (1 cup size) on the dispenser tray centered in front of the water dispenser paddle.

A

B

A. Water dispenser paddle B. Measuring cup (1 cup)

“Confirm” to confirm the calibration.

5. When Measured Fill calibration has been

confirmed the icons will disappear and the

display will return to the home screen.

A

A. 1 cup of water

14 15